An Easy Guide to Upgrading

[bakntyme]

Originally Posted by rpwallin

I ran the unlocker and the DCD301ROM on my phone. Now, it just goes to the Verizon screen and that’s it. The screen flashes up the stuff below and then just sits at the Verizon screen. Is there anything I can do to get it working again?

M 09
B 03
P ACAAAAM-4070
R 1.30.60
D 3.35

RTFM!

Reading the instructions would probably have helped.

Originally Posted by eehrhard

DCD has released a new ROM based on the 3.35 Sprint Rom.

There are issues installing the new radio on its own so DCD is suggesting that you install the 3.35 ROM first and then use the kitchen.

Get it here:
http://forum.xda-developers.com/showthread.php?t=376150

3/12 - 3.0.1 now availble Changelog in second post on xda link

Originally Posted by dcd1182

There are currently issues loading the radio. At this time, use the kitchen only if you know what you are doing and have managed to get the new radio installed on your own.
...
NO RADIO IS INCLUDED. RADIO 1.XX AND 2.XX ARE NOT COMPATIBLE!!
Radio ROM 3.35.04 is REQUIRED.

Originally Posted by dcd1182

...
At this time, as much as this sucks, this is the most stable method I have found of flashing the radio:

1. If you have not already done so, run the 2.40-olipro unlocker. Your device will again be left in tri-color screen.
2. Flash the official sprint 3.35 update.
3. When the device boots for the first time, do not pass screen calibration. Flash a 3.x.x ROM.

You did not install the new radio first. Assuming that you installed the proper unlocker (Olipro hard-SPL 2.40), you can put your phone into bootloader and start at step 2 immediately above.