Quote:
Originally Posted by Sifter
Started out with Sprints 2.17 stock ROM .
USB cable connected to phone and recognized in activesync.
Launch the new ROM exe file.
Verifies connectivity with the phone and existing version, 2.17.
Starts to install...
Multi-color screen comes up on the phone...
Then changes to the grey progress bar...
Works its way to 11%...
Phone goes back to multi-colored screen...
Computer stays on 11%.
Finally after about 60 seconds, computer comes back with ERROR 290: INVALID COMMAND, and my only options are to start the recovery.
I go through the recovery...
And the same loop starts again as described above. I have allowed this about 7 times.
I have used the titan_exitbl.exe and the phone boots back into the 2.17 ROM.
Any ideas?
|
I too had this happen four times...
Try downloading the Relocker mentioned earlier in this thread...run that...it will put a different bootloader on your phone, and then you can try the process over again. I couldn't get past 11% until I did this. Make sure to PAY ATTENTION to the dos screen, on every step, and remember that the instructions can refresh every step, so READ CAREFULLY!!
After doing that, you should have a 1.06 bootloader on your phone. then try the rom again and report back. That should take care of you, did for me.