|
||||
Quote:
<edit> For future reference, there is a sticky about 3 threads below this one that lists which cabs are necessary for each carrier. Here's the link: http://forum.ppcgeeks.com/showthread.php?t=3660 </edit>
__________________
One ROM to rule them all,
One ROM to find them. One ROM to bring them all, And in the kitchen, bind them. |
|
||||
So I can do a soft reset before it does the customizing part and then just install the CABs listed on that page? Basically I want the WM6 on my 6700 but would like to get rid of programs like Audible, etc.
|
|
||||
You won't need to install any of the CABs listed if you install one of the pre-customized ROMs. For instance, the Sprint ROM minus the customizing after reset stuff still has all the Sprint customizations that are needed to function and connect, but none of the junkware like the Audible stuff.
__________________
The only way of discovering the limits of the possible is to venture a little way past them into the impossible. Any sufficiently advanced technology is indistinguishable from magic. |
|
||||
Since it was just pointed out that Blade's Triangle Powers site is up and running again... I wonder if anyone has any suggestions (preferably from experience) as to whether an Apache running WM6 should use the PPC6700 Hacks or the PPC6800 Hacks CAB? The hacks are more dependent on the ROM than on the actual hardware... sooooo?
|
|
||||
Quote:
If you plan on using any of the custom rom then do not let the customization software run afer the first reset. The device must be soft reset again when it say "... 3 seconds.." (something like that anyway)
__________________
Sprint SERO: PPC6700 --> Mogul --> vogue --> TouchPro 2/HTC Hero
|
|
||||
Quote:
|
|
||||
Sounds like you either A) didn't soft reset while the "Customizing in 3..2.." prompt was up or B) didn't hard reset after flashing the rom. To fix either problem, just hard reset now (hold down the keys found above the "begin call" and "end call" buttons while sticking the stylus in the reset button hole.) If you don't see "press Y to restore to default", then you didn't hard reset. Once it resets, just make sure you soft reset during the "customizing..." prompt.
|
|
|
|