Adrynalyne's CC20 6.1 ROMs v. 1.7 Build 21051

[Robtao]

I am not known for being mainstream, but this will probably clinch it. Any CAB possibilities for putting the phone ringtone escalation back, or making it optional? I actually liked that it didn't start out at the full volume that I usually have set. Anybody else? At all?...

[Adrynalyne]

You can reverse it via the registry.

Hang on.

[Adrynalyne]

HKCU\ControlPanel\SoundCategories\Ring\Attenuation Category


Change this value to 2.

[Robtao]

Originally Posted by Adrynalyne

HKCU\ControlPanel\SoundCategories\Ring\Attenuation Category


Change this value to 2.

Thank you sir.

[Robtao]

Originally Posted by fkasten

I can't get UMDL to detect my phone. Should I have turned the "allow USB connections" setting back on after I connected and turned on the phone?

No. You may not have the drivers properly installed, or you may not be turning the phone completely OFF by holding down the power button.

[yotamaster]

I am new to rom flashing, and have searched and have not been able to come to an answer yet. I downloaded Adrynalyne's 1.0 rom, and have extracted it. The whole UMDL concept isn't quite clicking with me, it sounds to me like an application on the PC that will flash the rom to the phone? I cannot find this UMDL at all, any help?

This is the i910, never been flashed (has had a hard reset..)

[Robtao]

Originally Posted by yotamaster

I am new to rom flashing, and have searched and have not been able to come to an answer yet. I downloaded Adrynalyne's 1.0 rom, and have extracted it. The whole UMDL concept isn't quite clicking with me, it sounds to me like an application on the PC that will flash the rom to the phone? I cannot find this UMDL at all, any help?

This is the i910, never been flashed (has had a hard reset..)

It comes with the leaked ROM, which can be found in the thread called the Beta ROM http://forum.ppcgeeks.com/showthread...highlight=beta . Flash that first according to instructions on the first page and other posts in this thread. You need your driver from your Omnia disc properly installed on your PC, and off means OFF (hold the button).

[gruven98]

Originally Posted by yotamaster

I am new to rom flashing, and have searched and have not been able to come to an answer yet. I downloaded Adrynalyne's 1.0 rom, and have extracted it. The whole UMDL concept isn't quite clicking with me, it sounds to me like an application on the PC that will flash the rom to the phone? I cannot find this UMDL at all, any help?

This is the i910, never been flashed (has had a hard reset..)

this is where i downloaded the "unofficial rom" from; along with the instructions.

http://www.modaco.com/content/i9x0-o...or-omnia-i910/

robtao was correct in saying that you need your cd that came with your phone to install the driver needed to basically turn your phone into an external modem.

so... on that note....

1. install the driver
2. uncheck "allow usb connections" in active sync
3. flash your phone per the pdf doc that you downloaded from above
4. once that's all done, now it's Big A's rom turn (same rules apply)
** the only difference here is that you click on PDA in the umdl program **
5. run the umdl program in the same manner

all set... if there's anything else, i know that there's plenty of folks in here to help you out. enjoy!

[ikelo]

what is the driver from the cd that came with the phone? what does it do, and why is it needed?

i have done the rom flashes, and everything is working fine, and i haven't used any drivers from a cd....?

[smurfbiterjay]

Adrynalyne, thanks for the fast response time on the bluetooth issue, so far everything is rockin pretty good!