How to get iGo8 run on TP2 with TTS enable and 2009 NA Maps (step by step guide)

lotus f1 · #1 (**permalink**) 10-05-2009, 02:12 AM

I have the speedcam folder and the download but the option does not show up in the "warnings" menu.

Also.. you state that you have attached a new sys.txt with the changes. I do not see that link on your post nor your download file of the tts files. Where is it?

Ender519 · #2 (**permalink**) 10-05-2009, 12:09 PM

Quote:

Originally Posted by lotus f1

I have the speedcam folder and the download but the option does not show up in the "warnings" menu.

Also.. you state that you have attached a new sys.txt with the changes. I do not see that link on your post nor your download file of the tts files. Where is it?

Speedcam warnings.. The Speed Camera Warning selection box only appears after the device is receiving a good GPS signal (e.g., not usually indoors). Make sure your GPS is connected w/ good signal and try again.

SYS.TXT was included with the ZIP file for the TTS voices, but if you want you can just grab the relevant code from my post and add to yours.