Treo Pro CDMA HardSPL

[tel-x]

Thank you guys for all your hard work, too often it is overlooked.
-Telx

[nctrevor24]

Originally Posted by Vip3rV333

I had problems too. Here's what made it work for me. Start the Hard-SPl app and keep going with the steps till your at the last one where you get the tri-colored screen on the phone. Don't start the flashing process just yet. Disconnect the cable and plug it back in. The phone should be detected and then hit next and it should flash.

I was trying for hours to get this to work and doing what u said did it for me thank you so much

and thanks guys for the hard work i work for sprint so ive had this phone since before its release date i had a diamond before so i was accustom to cooked roms and couldnt wait for this one to be done thanks again

[ra1254]

Thanks great work!

[mth91]

Do you use this before or after you flash with CFay's ROM?

[acidhax]

Originally Posted by mth91

Do you use this before or after you flash with CFay's ROM?

Before. You need to unlock your phone for it to accept an 'unsigned' rom, such as CFay's .

[davidck65]

I unlocked my phone and tried both of the new 6.5 ROMs. Since then I have gone back to the 6.1 ROM by using the 1.04 update for now. I was not sure if I needed to reinstall the Treo Pro Ringer Update so I tried. It errors out saying Incorrect Software Version install is aborted. Do I need to install this update or is it there because of the Sprite backup I reinstalled? Also, does this mean that by unlocking our phones that we will not be able to install any new Palm updates?

[khalaan]

David,
You will still be able to install any up-dates Palm may release. However since Palm has essentially discontinued the Treo line here forward, I doubt we will see anything official from them.

[davidck65]

Originally Posted by khalaan

David,
You will still be able to install any up-dates Palm may release. However since Palm has essentially discontinued the Treo line here forward, I doubt we will see anything official from them.

Any idea why the update ringer cab won't install due to wrong software version? I know that previous to unlocking when I installed it a second time it stated that the previous version would be removed. So, I am unsure at this point if the cab is installed. I had it installed previous to doing a full Sprite backup. I tried both ROMs and then flashed back to 1.04 and then restored my Sprite backup. I would think that means the ringer update would still be in effect.

[salzion]

Alright, after messing with it about 20 times, I finally got this to flash and so forth.

I followed RKnight and someone else's suggestion of dling the enablerapinew.cab and starting the process, then disconnecting the phone and reconnecting it.

Thanks guys.

[JCSands]

I flashed to 6.5.1 ROM and installed the ringer update without issue. Not sure what your problem is there.