Treo Pro CDMA HardSPL

[madvek]

Thanks will do, sorry bout that.

Done! Success! thanks again.

[aeropatel]

Works great if you run the hslp, but have to unplug the usb drive and then replug it in...only way it works for me...thanks

[DssTrainer]

Originally Posted by juttonn

I'm getting the same result. I bought the Treo Pro for my wife on ebay and it didn't come with a USB cable. The other thing I tried was going into the boot loader (hold down power and camera button and then pushing soft reset button). When I do that i briefly get the tri-color screen, then the screen goes gray and says "Loading..." But it hangs there forever (I left it there for 30 minutes or so).

I tried redownloading files, I made sure the SD card is fat32, etc. Anyone have any other ideas? Thanks

Same issue here. the SD load method worked fine for roms when its already 0.36 but when its 0.32 and you are trying to load the hardspl.. it does nothing.

[DssTrainer]

Seems the SSPL Manual exe program doesn't work. (i know it used to). But even after flashing the hardspl using the cable, the SSPL manual program would show tricolor and 0.32 and wouldn't start loading the nbh from ile on the sdcard. So I used the Camera+Power+Reset method and it showed 0.36 and found the image and began loading it.

So maybe using the camera trick instead of SSPL manual is the trick to get the hardspl to load from the sd as well.

[agibby5]

Originally Posted by davidck65

I had the same issue. Downloaded and installed the enablerapinew.cab referenced in the update program and then while the program was verifying I unplugged the sync cable and plugged it back in. Then it worked!

I had error 260 too, and this worked for me. Thanks!

[cdene]

Not sure what im doing wrong copied file to sd card renamed to pantimg.nbh copied the manual.exe to device and ran it but it just stays on tricolor screen it never loads nbh file. did i miss a step.
Thanks

[cdene]

Ok i have tried every solution listed and none of them work. what am i doing wrong?
thank you

[skeegcpp]

Originally Posted by cdene

Not sure what im doing wrong copied file to sd card renamed to pantimg.nbh copied the manual.exe to device and ran it but it just stays on tricolor screen it never loads nbh file. did i miss a step.
Thanks

Ok i have tried every solution listed and none of them work. what am i doing wrong?
thank you

is the sd card formatted to fat32? and i dont think u need the manual.exe...as long as u can enter bootloader(camera+power+reset with stylus)
any other rom images on the root of the sd card?
have u tried unlocking via usb?

[cdene]

yes tried the usb to when i dissconnecing and reconnect nothing happens and phone loses connection. Also after i insert the card a file named encfiltlog.menc file appears what is that file.
thanks

[cdene]

Got it thanks used the usb method again seems i did not disconnect and reconnect at the right time.

Thank you