Uscc 6800 Gps, Custom Roms, Downgrading Guide

[President Fluid]

I was gonna give mine some goofy name but when I did the change from cellsouth I couldn't think of any.

[chaser74]

active sync will not reconize the phone when you are in boot loader. once the phone is in boot loader you can run the radio rom and then continue on

Originally Posted by chaser74

active sync will not reconize the phone when you are in boot loader. once the phone is in boot loader you can run the radio rom and then continue on

At one point, the screen said something like 2.40 boot loader, but how do I get to that from here?

[President Fluid]

Use BuildOS and build your ROM. Follow the directions from there in the first post of the thread on BuildOS.

Originally Posted by President Fluid

Use BuildOS and build your ROM. Follow the directions from there in the first post of the thread on BuildOS.

I tried it, and I got the kitchen to build a rom, but when it tries to update the phone, it shows the percentage completed bar on the computer and the phone, but then I get an "Error 262: update error"

I also noticed that the PDA phone ROM Update Utility 3.16.4.2 screen said that the "Current information about your PDA phone:
Verify:
From: Image Version: <blank>

To: Image Version: 5060

Then after I got that is when I got the Error 262.

I need a vicodin.

Thanks for your help!!

[chaser74]

looking at your original post it woulds seem you have he wrong spl. Did you follow the directions exactly at the begining of this thread. did you install the hard lokc SPL in the first post? you will need to install that before you can do anyrthing else. then the radio then the custom rom

Originally Posted by chaser74

looking at your original post it woulds seem you have he wrong spl. Did you follow the directions exactly at the begining of this thread. did you install the hard lokc SPL in the first post? you will need to install that before you can do anyrthing else. then the radio then the custom rom

Well, I tried the whole process over again and when I try to run Hard SPL MFG.exe I get an error that says no device connected would you like to try to copy again?

For some reason, it doesn't seem to want to connect even though it's recognized as a USB device, and the screen changes to the percentage completed bar when I try the Titan radio.

[chaser74]

if you are trying to run the hardsplmfg.exe with the 6800 in bootloader it will not work.

Well I finally got the bootloader thing to work, I just redid the whole thing but I had to uncheck a box in >settings>connections>usb to pc> "Enable advanced network functions." That's when the magic happened.

I flashed a new rom, but now I can't get data to work. All else seems to run well. I ran BitPIM, but it can't find the "generic serial" device drivers it needs. Wow, I have to apologize for being such a pain in the butt. You guys have the patience of Job, but I appreciate the help.

99% of the time your EPST settings are wrong.
Go into EPST in edit mode and select the security tab.
Make sure the settings are like the post below:

http://forum.ppcgeeks.com/showpost.p...&postcount=151