Uscc 6800 Gps, Custom Roms, Downgrading Guide

[President Fluid]

Yea myou can do it with it being deactivated.
What step did you get all confused at then gave up?

[JAEPILLA]

has anybody ever got stuck on the htc screen? i was in the process of updating the rom.. i was loading on the radio when the phone got to the part where it resets itself it never got p***** the htc screen... i've tried reset, hard reset, removing the battery.. everything now i can't get p***** this screen, im suppsed to be on the last step of cooking the rom and putting it on the phone but i can't get an active sync connection because the phone won't load up.. any suggestions pepole?

[President Fluid]

If you have the radio installed try holding the Power and Camera buttons while pressing the soft reset button. That will take you into the BootLoader. Then try cooking another ROM.

[JAEPILLA]

Ill Give It A Shot

[JAEPILLA]

OK IT WORKED BUT IM STUCK AT WORK SO I CAN'T COMPLETE THE UPGRADE PROCESS..iupdated you all later after i get off

[JAEPILLA]

ok back at home, i did the reset to get it back into boot loader but i can't cook the roms and add them on because it can't connect to active sync whie in bootlader,

so i tried to run the radio again but it won't complete now it goes to about 8% and stops and reads ERROR 328, and says that it can't be used for my pda phone and resets right back to the htc screen..i know i already completed this step.. so i tried doing it all over from step 1 and that doesn't work either..any suggestions?

do i need another radio possibly?

[President Fluid]

Don't worry about active sync......... As long as you are doing this active sync wont connect....

As long as you got the radio installed cooking the rom should be no problem.

Put the phone into boot loader mode then connect it via the usb.

Start buildOS and follow the dirrections from there.

[JAEPILLA]

im trying but im getting an error ,.. the application failed to initialize properly (0xc0000135) then it tells me to push ok to terminate the program.. i already disabled active sync, i read on anther thread about the 3 tasks that u have to close out.. but im still getting this error?

[puff]

Originally Posted by JAEPILLA

im trying but im getting an error ,.. the application failed to initialize properly (0xc0000135) then it tells me to push ok to terminate the program.. i already disabled active sync, i read on anther thread about the 3 tasks that u have to close out.. but im still getting this error?

Think that means you need to install .net framework...

Originally Posted by gguruusa

Correct. 0x0000000135 means .net is not installed.

[JAEPILLA]

and how do i do this?