Change TP2 MSL Code to 000000 - Page 4

**pimpsuprazx** · #31 (**permalink**) 10-10-2009, 01:26 PM

Quote:

Originally Posted by Informed101

That's what I did first but when I mouse over the place where it says COM1 on the bottom of the 2.7 screen nothing happens. No drop down. Nothing. It just stays 2.7.

not there, under main tab, then com settings(at mode), it says port, then com1 then you click there.

Informed101 · #32 (**permalink**) 10-10-2009, 02:01 PM

pimpsuprazx You are totally awesome!!!!!
Thank you so much for your help and patience!!!!!

Now on to the next step of the TP2 conversion....

**pimpsuprazx** · #33 (**permalink**) 10-10-2009, 02:11 PM

Quote:

Originally Posted by Informed101

pimpsuprazx You are totally awesome!!!!!
Thank you so much for your help and patience!!!!!

Now on to the next step of the TP2 conversion....

no prob, now you just need to follow the flash to metro pcs guide and upload the PRL, then have it houdinied and your up and running.

Informed101 · #34 (**permalink**) 10-12-2009, 03:34 AM

Thanks again PimpSupraZX for all your help. =D>

Well, I think I followed the guide, step by step. Went to 3 different Metro PCS stores, 2 corporate, one authorized, and non could flash.

Any suggestions? Anyone in LA who can flash it?

Is there a way I can check it to make sure I've done all the steps right? I do know that when I enter the 000000 it gets me into the edit page so at least that much is sure. I also put the 02001.prl file on my TP2 and followed the instructions to put it in. Not sure how to check if it went in ok.

Houdini is the program all MetroPCS dealers use? Or just certain shops?

When I dial *228 I get the MetroPCS welcome. So far so good? Just flashing then?

**pimpsuprazx** · #35 (**permalink**) 10-12-2009, 09:00 AM

Quote:

Originally Posted by Informed101

Thanks again PimpSupraZX for all your help. =D>

Well, I think I followed the guide, step by step. Went to 3 different Metro PCS stores, 2 corporate, one authorized, and non could flash.

Any suggestions? Anyone in LA who can flash it?

Is there a way I can check it to make sure I've done all the steps right? I do know that when I enter the 000000 it gets me into the edit page so at least that much is sure. I also put the 02001.prl file on my TP2 and followed the instructions to put it in. Not sure how to check if it went in ok.

Houdini is the program all MetroPCS dealers use? Or just certain shops?

When I dial *228 I get the MetroPCS welcome. So far so good? Just flashing then?

Its certain shops, go on howard forums.com and get a hold of reemo4580
I personally know he is in LA and flashed tp2's before. And to answer your question, if the PRL is updated, and you changed the MSL code, good job btw, it flashes just like a touch pro does, so those people unforunately do not know what they are doing.