Treo Pro CDMA HardSPL

[Vip3rV333]

Originally Posted by cmonex

oh, it's not hard to get, extract it from resource section (after unpacking exe with upx) but I can post the NBH. let me know if needed.

Can you please post it?

EDIT: Looks like I figured it out... Thanks for everything anyways tough!

[RKnight]

Originally Posted by cmonex

you must read the instructions properly. phone must be in WM and syncd.

I have read all of the instructions and followed everything to the T.

Originally Posted by cmonex

oh, it's not hard to get, extract it from resource section (after unpacking exe with upx) but I can post the NBH. let me know if needed.

This would help me huge if I could just flash my wifes phone from the SD. I tried extracting using UPX and 7zip and no luck with either 7zip gave me broken errors when I tried and UPX didn't work at all for me.
thanks for your help and hope you have a solutions for me.

[Vip3rV333]

I had problems too. Here's what made it work for me. Start the Hard-SPl app and keep going with the steps till your at the last one where you get the tri-colored screen on the phone. Don't start the flashing process just yet. Disconnect the cable and plug it back in. The phone should be detected and then hit next and it should flash.

[RKnight]

I was finally able to unlock my wifes phone. I tried downloading the files with Internet Explorer and d/l them to the desktop and tried everyhing over again. I dont know if I had a bad d/l the first time or what but phone is unlocked and now running 6.5.1. thank you for your hard work getting the program to work, and for cfay for the testing. The flashing of the ROM went alot better since I just reneamed the .nbh file and flashed from the SD card (fasted and easiest way to flash). thanks again

[tel-x]

Thank you guys for all your hard work, too often it is overlooked.
-Telx

[ra1254]

Thanks great work!

[mth91]

Do you use this before or after you flash with CFay's ROM?

[acidhax]

Originally Posted by mth91

Do you use this before or after you flash with CFay's ROM?

Before. You need to unlock your phone for it to accept an 'unsigned' rom, such as CFay's .

[davidck65]

I unlocked my phone and tried both of the new 6.5 ROMs. Since then I have gone back to the 6.1 ROM by using the 1.04 update for now. I was not sure if I needed to reinstall the Treo Pro Ringer Update so I tried. It errors out saying Incorrect Software Version install is aborted. Do I need to install this update or is it there because of the Sprite backup I reinstalled? Also, does this mean that by unlocking our phones that we will not be able to install any new Palm updates?

[khalaan]

David,
You will still be able to install any up-dates Palm may release. However since Palm has essentially discontinued the Treo line here forward, I doubt we will see anything official from them.