OTA Sprint PRL update on Juicy

[kaos4u2nv]

Sorry, but what is the PRL used for? I don't seem to understand the need for this...can someone please explain?

[jgillard]

PRL is preferred roaming list. It lets the phone know what towers it can roam to.

[statepkt]

^Yeah, basically newer PRL's can help your signal coverage

[jonnyboy313]

Originally Posted by statepkt

FYI, for all the Sprint people who don't what their MSL is:

I found this procedure on the xda forum and it works!!

I found a method that actually worked perfectly...

Use this method. I don't know who found it, but credit goes to them.

Change the following registry entries in:
HKEY_LOCAL_MACHINE\SOFTWARE\HTC\ATDbgLog
Enable: 1
LogMode: 1

* Wait a about 10 minutes (more time will not hurt), and soft-reset.

* Check to see that the file \Atlog\ATDbg0.txt has been created.

* Return the values back to what they were (most likely 0) waiting the same amount of time as above.

* Look in the ATDbg0.txt file and you should see a log of commands sent to the CDMA radio and there should be something like this somewhere in the file:

~~~~~~~~~~~SNIP~~~~~~~~~~~~
00:00:00 Tx:AT+HTC_RMSL=0\r
00:00:00 Rx:+HTC_RMSL: (###THIS WILL BE THE MSL###)\r\n0\r
00:00:00 Tx:AT+HTC_ROTKSL=0\r
00:00:00 Rx:+HTC_ROTKSL: 123456\r\n0\r
~~~~~~~~~~~SNIP~~~~~~~~~~~~


The numbers next to the Rx: +HTC_RMSL line should be your MSL

I was wondering the best program to do this reg edit, I must get that unlock code, I have been flashing My titan for a while, only needed the GetSpc for the code. Tried the GetSPC then with the .dll download for Sprint Diamond, no luck, then tried cdma workshop. wont pay a hundred bucks for the code.

One thing that im not sure about is I just bought this from a friend,
and its not activated yet. Could that be a problem?

I have unlocked and flashed the phone with no problems, but im waiting to do the radio because of this code. To avoid other problems later

I have never edited registry before, but i feel there is no other option.
Any help would be greatly appreitied.

[jonnyboy313]

I Have followed the steps indicated, waited 15min, and soft reset. the \Atlog\ATDbg0.txt was not created.
If it has been created maybe im not seeing it. ( I assumed it would be where i made the changes)

One thing i should note my phone has not been activated through sprint yet.(trying to get it set up before activation.

Thanx for the help

[LilRico]

This is what I've been using on my Sprint TP and Diamond PRL 60650
http://forum.ppcgeeks.com/showthread...ighlight=60650

[The Doctor]

Ya, here it is.
Just change ".txt" to ".prl"