Stuck in TITAN bootloader? Read this! - Page 20

6700noobie · #**191** (**permalink**) 03-26-2010, 04:40 PM

After installing the unlocker with win 7 64bit, the unlocker couldn't exit bootloader and running the unicode bootloader exit exe kept coming back with unable to establish a USb connection to the phone even though Mobile Device Center was completely shutdown. Used MTTY from the kitchen, connected via USB and typed in the "set 16 0" command then reset and viola out of bootloader and it restarted normally.

Thanks ImCoKeMaN!

corrsea · #**192** (**permalink**) 01-31-2011, 12:41 AM

If like me you have worked your way through this forum without success don't give up. In the end I read a suggestion on another forum which advised to use the back usb connection on your PC. It worked straight off and I was able to flash a new ROM.

**Tinkerbell** · #**193** (**permalink**) 01-31-2011, 12:53 AM

Cool suggestion. Sometimes changing USB ports forces your computer to install the drivers again for your device. In your case, the correct drivers were installed and Bingo!! Thank you for your imput!! =]=]

Dragon2000 · #**194** (**permalink**) 03-09-2011, 01:21 AM

Somebody please help! I have done everything in this forum and my phone is still "bricked". All I get is a message box saying cannot open USB port. Can somebody help me?

webs05 · #**195** (**permalink**) 03-09-2011, 06:28 PM

Quote:

Originally Posted by Dragon2000

Somebody please help! I have done everything in this forum and my phone is still "bricked". All I get is a message box saying cannot open USB port. Can somebody help me?

Need more info, what are you trying to do? What was the last thing you did? What steps have you tried?

The more specific you can be the more help people can give you.

ddfuji · #**196** (**permalink**) 07-08-2011, 12:59 PM

Quote:

Originally Posted by Soulmatic

im stuck in bootloader after trying to flash the new rom to my friends mogul.. the flashing kept stopping at 11% then after a couple times, it told me to restart pc,, but when i did that, i couldnt restart rom update.. (cause to start rom update it has to connect to activesync first?)

with the following on tricolor screen:
TITA100
SPL-1.20.Olipro

i tried the exit bootloader given in this thread.. but that doesnt work (and yes i made sure activesync was disabled)

what do i do?

im having the same exact problem. except my screen says spl-2.40 olipro. i tried using the titan_exitbl. and it didnt work and says that i need to deactivate usb connection in active sync (which i did) nothing is working

i need help. its still stuck in bootloader.

**Tinkerbell** · #**197** (**permalink**) 07-08-2011, 03:19 PM

What Rom are you trying to flash? When you plug and unplug the mini USB connector, does the wording at the bottom of the Titan's screen change from serial to usb? Or does it just stay at serial?

buddysousa · #**198** (**permalink**) 07-08-2011, 05:57 PM

Quote:

Originally Posted by Tinkerbell

What Rom are you trying to flash? When you plug and unplug the mini USB connector, does the wording at the bottom of the Titan's screen change from serial to usb? Or does it just stay at serial?

Good thought Tink