Stuck, Progress bar won't move during unlock

[Slevin]

Originally Posted by Ga. Medic

To get into bootloader you hit power, camera, reset. Make sure you hold all three for about 2-3 seconds. The spl you have is not the updated one. The spl should read 2.47 when you have done it correctly.

Yeah, but I can't get the process to complete. It just hangs at the progress screen and doesn't update??? I don't know why?

-Slevin

[cornelious2]

do you have the NUESPL cab on the sd card when you run the update? I dont know if it matters but thats what I did when I ran it.

[Slevin]

Originally Posted by cornelious2

do you have the NUESPL cab on the sd card when you run the update? I dont know if it matters but thats what I did when I ran it.

Yeah, on the SD card is nueSPL-2.47.exe I run that and it goes throughthe process, I get checkmarks on the pre-checks, it resets to the bootloader, the switches to a screen Loading.... and the just goes back to the stock bootloader after a few. I just don't understand it.

-Slevin

[Slevin]

Anyone have any other ideas??? I can't stand this stock ROM, I can't get on the internet with internet sharing???

-Slevin

[ImCoKeMaN]

what happens when you try the 2.40 unlocker exactly? do you get the activesync processes to work and have it load up the soft bootloader?

[bakntyme]

Originally Posted by Slevin

Yeah, on the SD card is nueSPL-2.47.exe I run that and it goes throughthe process, I get checkmarks on the pre-checks, it resets to the bootloader, the switches to a screen Loading.... and the just goes back to the stock bootloader after a few. I just don't understand it.

-Slevin

I don't know if it makes a difference, but the instructions for nueSPL state to copy the .exe to the device, not the SD card.

Installation
Once you make sure you have meet all the necessary requirements:
1. Copy the nueSPL-2.47.exe file onto your device.
2. Run the application and accept the license agreement, then press [CONTINUE].
3. Read the prerequisite check screen carefully. If it indicates that you do not have a FAT32 formatted partition, you will need to format your microSD card by pressing [FORMAT].

Warning: Formatting your microSD card will destroy all data! Ensure that you have made backups of anything you wish to save.

4. If your card is already FAT32 formatted, and it has as least 1MB of space available, press [CONTINUE].
5. Press [CONTINUE] to begin the flashing proccess.
It will take approximately 10 seconds to complete, and your phone will reboot automatically.
If prompted, press the [POWER] button to begin updating.
6. Allow your phone to fully reboot. Once your phone is rebooted, open file explorer and inspect to see if your storage card contains the file TITAIMG.nbh. If it is present, delete it before continuing.
7. Press the [CAMERA], [POWER] and [RESET] buttons at the same time in order to enter the bootloader. You should see a screen that says SPL-2.47No2Chem Titan SPL EVT. If you see this text, your SPL has been sucessfully updated. If you do not, power off your phone and start over from step 1. To return back to your phone, press the [RESET] button.

Originally Posted by Slevin

Anyone have any other ideas??? I can't stand this stock ROM, I can't get on the internet with internet sharing???

-Slevin

TUTORIAL - How to tether using InternetSharing with new Official ROM!!
Says for the Touch, but allegedly works for the Titan also.

[bakntyme]

ping Slevin