07-03-2009, 02:41 PM
|
||||
|
||||
|
CC20 Doesn't load properly - Image and logs attached
I was trying to load CC20 with UMDL 2.3. The UMDL gets to Download image 100%. Then it just stops - no error message.
This is the log: PDA Device Found! [Port : 1]EBoot version = 01.35 ------------------------------------------------------------------------------------- PDA Device 1 ready to download! ------------------------------------------------------------------------------------- PDA Device 1 ready to download! ------------------------------------------------------------------------------------- PDA 1 starts downloading... Don't plug it out until the label becomes blue!!! ------------------------------------------------------------------------------------- EBOOT will be written. PDA will be written. PHONE will be written. ------------------------------------------------------------------------------------- Downloading EBOOT... [Port 1] Checksum Check :: ------------- (Device 1 log) Device name:5&2b986538&0&1 EBoot version=01.35 Start downloading... PDA-Starting updating EBOOT... PDA-Downloading EBOOT... --------------- This is what the phone looks like - a picture of an orange triangle with an exclamation point in it over an outline of a phone. And just one line of the green progress bar.  Additional info: If i press the little reset button on top then hold down the 2 buttons to format - it will slowly load up and boot into the phone. But obviously something didn't go right. I had been following instructions from here: http://www.modaco.com/content/i910-specifi...m-verizon-i910/ any ideas? |
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
All times are GMT -4. The time now is 07:29 AM.
