View Single Post
  #1 (permalink)  
Old 07-03-2009, 02:41 PM
xm81bpm's Avatar
xm81bpm
Lurker
Offline
 
Join Date: Sep 2008
Posts: 22
Reputation: 0
xm81bpm is a n00b
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
CC20 Doesn't load properly - Image and logs attached

I was trying to load CC20 with UMDL 2.3. The UMDL gets to Download image 100%. Then it just stops - no error message.

This is the log:

PDA Device Found!
[Port : 1]EBoot version = 01.35
-------------------------------------------------------------------------------------
PDA Device 1 ready to download!
-------------------------------------------------------------------------------------
PDA Device 1 ready to download!
-------------------------------------------------------------------------------------
PDA 1 starts downloading...
Don't plug it out until the label becomes blue!!!
-------------------------------------------------------------------------------------
EBOOT will be written.
PDA will be written.
PHONE will be written.
-------------------------------------------------------------------------------------
Downloading EBOOT...
[Port 1] Checksum Check ::


-------------
(Device 1 log)

Device name:5&2b986538&0&1
EBoot version=01.35
Start downloading...
PDA-Starting updating EBOOT...
PDA-Downloading EBOOT...

---------------
This is what the phone looks like - a picture of an orange triangle with an exclamation point in it over an outline of a phone. And just one line of the green progress bar.




Additional info: If i press the little reset button on top then hold down the 2 buttons to format - it will slowly load up and boot into the phone. But obviously something didn't go right.

I had been following instructions from here: http://www.modaco.com/content/i910-specifi...m-verizon-i910/

any ideas?