New Alltel 3.04.671.2 Rom Released, Rev A enabled - Page 49

tgrunwald · #**481** (**permalink**) 04-25-2008, 11:30 AM

Quote:

Originally Posted by Musicman247

No. Nobody has gotten GPS to work on JD's ROM. Even Mindfrost is going back to the Alltel ROM.

So it sounds like I should:
1) Install Unlocker 2.31
2) HArd Reset
3) Install Alltell ROM
4) Skip cusomizations (Cause I am using Sprint)
5) Hard Reset again

Now is that All I need to do to get REV-A and GPs on my Sprint Touch
or what am i missing?

naiserie · #**482** (**permalink**) 04-25-2008, 11:32 AM

Quote:

Originally Posted by Musicman247

No. Nobody has gotten GPS to work on JD's ROM. Even Mindfrost is going back to the Alltel ROM.

thanks, I figured as much. I think I'll hold out for another custom rom.

**mindfrost82** · #**483** (**permalink**) 04-25-2008, 11:36 AM

Quote:

Originally Posted by tgrunwald

So it sounds like I should:
1) Install Unlocker 2.31
2) HArd Reset
3) Install Alltell ROM
4) Skip cusomizations (Cause I am using Sprint)
5) Hard Reset again

Now is that All I need to do to get REV-A and GPs on my Sprint Touch
or what am i missing?

Here's a quick walkthrough I put together for the Alltel ROM:

http://forum.ppcgeeks.com/showthread.php?t=24925

PapaDocta · #**484** (**permalink**) 04-25-2008, 11:38 AM

for the internet connection has anyone tried to go to ##778 and then to Security and change the settings there? it worked for me but i'm not using sprint!! also removing the HTC_CM_Guardian .lnk in the startup folder... i hate that evil file!

matthew23 · #**485** (**permalink**) 04-25-2008, 11:38 AM

stupid stupid noob question: I am coming from one of the custom sprint WM6.1 roms which means I previously unlocked my phone using Cokeman's unlocking tool. I decided to pull the trigger and just do this Rom now. I downloaded Cokeman's 2.31 unlocker, hooked up my phone to active sync and ran the tool. I got me into the tricolor screen but then it only took like 10 seconds and said I was at 100% (when the instructions on the screen said it would take up to 10 minutes).

Is this nirmal? Did I not need to run the "new" tool?? It seems to load up ok but now when the screen goes off it won't turn back on (I have to soft reset and the same thing happens!!)

What do I need to do? I am sorry to detract from the progress of this thread. I have read this thread from the beginning and don't remember anyone having this problem.

thanks!

edit: I go into the bootloader screen and it does say "VOGU100 MFG SPL-2.31.CoKe CPLD-3

However, I cannot get out of standby - once the screen turns off, nothing will "wake it up." I have heard of problems like this with the vogue but never had it before this new bootloader...any recommendations?

dew.man · #**486** (**permalink**) 04-25-2008, 11:40 AM

Quote:

Originally Posted by matthew23

stupid stupid noob question: I am coming from one of the custom sprint WM6.1 roms which means I previously unlocked my phone using Cokeman's unlocking tool. I decided to pull the trigger and just do this Rom now. I downloaded Cokeman's 2.31 unlocker, hooked up my phone to active sync and ran the tool. I got me into the tricolor screen but then it only took like 10 seconds and said I was at 100% (when the instructions on the screen said it would take up to 10 minutes).

Is this nirmal? Did I not need to run the "new" tool?? It seems to load up ok but now when the screen goes off it won't turn back on (I have to soft reset and the same thing happens!!)

What do I need to do? I am sorry to detract from the progress of this thread. I have read this thread from the beginning and don't remember anyone having this problem.

thanks!

Boot in to the loader with power+camera+reset, and make sure it says 2.31