Unlockers for Custom Roms on Vogue 2.31(GPS) and 0.40(nonGPS) - Page 23

**ImCoKeMaN** · #**221** (**permalink**) 04-24-2008, 10:06 PM

This won't do it by itself. It would still take research and time to have you test things while i look into it. If you can get a new one easily go for it, but i wouldn't lose all hope if you have time. Check chat i'm not always there, but i am now

mardukeme · #**222** (**permalink**) 04-24-2008, 10:14 PM

I am having a problem running the your new Unlocker. I keep recieving the following error" "No Device Connected" would you like to try copying again?

**ImCoKeMaN** · #**223** (**permalink**) 04-24-2008, 10:32 PM

device has to be in OS and connected to activesync to copy files and start its loader. Also the exe has to be run, not extracted.

mardukeme · #**224** (**permalink**) 04-24-2008, 10:43 PM

Sorry I forgot to mention I already had installed the Alltel radio rom and my phone will not boot. I can put the phone in boot loader mode that's about it. Also is there a way to copy the files over to the memory card and run them from there?

**ImCoKeMaN** · #**225** (**permalink**) 04-24-2008, 10:46 PM

Please see post 222, this will not unbrick your device as it needs a booting OS, or unlocked SPL to flash.

**mindfrost82** · #**226** (**permalink**) 04-24-2008, 10:59 PM

How can I check that the new unlocker is installed correctly on my phone? I ran it, it went through all of the steps, then after it reset it loaded up my old ROM (like I just did a hard reset). I don't want to run the Alltel ROM until I know the unlocker is installed correctly.

**ImCoKeMaN** · #**227** (**permalink**) 04-24-2008, 11:04 PM

power - camera - reset the unlocker will show 2.31.CoKe

**mindfrost82** · #**228** (**permalink**) 04-24-2008, 11:19 PM

Quick and dirty installation guide:

- Connect the phone via usb to activesync
- Run the unlocker exe (will open a command prompt with instructions)
- Follow all of the prompts by the unlocker
- When its finished it'll reboot (and take a while) and it'll reboot with your past ROM like you just did a hard reset
- After that's finished, do the Power-Camera-Reset to get into the new bootloader (rainbow screen like before)
- Connect to the computer via USB
- Run the Alltel exe (it take a while to install compared to the custom ROMs, it will also act like it gets stuck around 11%, but that might be because it loads a radio ROM and OS ROM)