I need some help w/ my sprint TP, kind of in a pickle

[erockvr6]

Originally Posted by arbdef

I had that happen on my 6700. Something that worked was I used a little bit of mass air flow sensor cleaner (aka electronics cleaner) and it cleaned off the pins making it so I could charge/sync again. Sometimes garbage builds up on the pins and a cleaning is all it needs. If that doesn't work is there a crack on the board where the usb plugs in?

You can get a can of the sensor cleaner at any auto parts store.

i will def try that, i did notice some gunk build up in there, nothing real bad, but i didnt think it would matter, i will def try that, also does anyone kno about the flashing via sd and having low battery, will it work?

[arbdef]

Originally Posted by erockvr6

i will def try that, i did notice some gunk build up in there, nothing real bad, but i didnt think it would matter, i will def try that, also does anyone kno about the flashing via sd and having low battery, will it work?

I guess i should mention this but take your battery out before doing that and give it a minute to dry out. Im sure you knew that but still

[erockvr6]

Originally Posted by arbdef

I guess i should mention this but take your battery out before doing that and give it a minute to dry out. Im sure you knew that but still

haha, ya thanks

[erockvr6]

Originally Posted by erockvr6

i will def try that, i did notice some gunk build up in there, nothing real bad, but i didnt think it would matter, i will def try that, also does anyone kno about the flashing via sd and having low battery, will it work?

so i tried cleaning out the port but i got the same results, charges for bout 2mins and stops, but i did manage to reflash to stock and relock it too, so i guess i'll just take it to the service center.