|
||||
Re: Please help to un-brick my bell Touch PRO
Quote:
------------------------------------------------ Flashing Via MicroSD Card 1. Make sure your microSD is Formatted to fat32 using a PC (you dont have to delete all files but it is safer if you do) 2. Download your prefered Rom from the Raphael Rom Develpoment Page and unzip/unrar it to your computer 3. Goto the Roms Folder and rename the .nbh file to RAPHIMG.nbh 4. Copy the RAPHIMG.nbh file to the root of your microSD Card 5. Remove Sim Card and Restart phone 6. Plug the microSD Card into the phone 7. Press and hold the volume down button, then press the reset button with the stylus. Release the volume down button when bootloader tricolour screen appears 8. Follow the onscreen instructions to start flashing 9. Once phone finishes flashing and says Update Complete, reset with the stylus 10. When it gets to the screen where it configures the stylus, HARD RESET (hold the VOLUME DOWN and ENTER (center) Buttons, press the RESET button with the stylus tip, then release the RESET button but continue to hold the VOLUME DOWN and ENTER buttons until the reset screen appears) 11. Follow onscreen instructions to set up your New Rom |
This post has been thanked 1 times. |
This post has been thanked 1 times. |
|
||||
Re: Please help to un-brick my bell Touch PRO
Quote:
|
|
||||
Re: Please help to un-brick my bell Touch PRO
Thanks for all the info, I was having the same issue with my Sprint Touch Pro, and after 25 times via USB and a couple of microSD attempts, I was finally able to get the MightyROM5 to install from my microSD.
Previous attempts had looked good, and went 100%, but got locked into a reboot loop. ![]() I'm not sure what was different, but I did reformat the microSD and rename the ROM to RALPHIMG.nbh, but I could not get the EnergyROM to work. Thanks to Everyone involved. Off to resync and setup email, etc. |
![]() |
|
|
|