03-27-2009, 11:33 PM
|
||||
|
||||
|
Reading pim.vol file
I had a strange phone freak out, which I immediately backed up my pim.vol file to save my contacts like I always do. Now, it seems whenever I use total commander to restore the file, my phone radio dies and tells me I have no service. I also get no access to my contacts, no dialer and no anything. I believe the file is corrupted but was wondering if there is any way to manually edit the file, as to at least be able to read my contacts.
There are probably 15 different new contacts that I would like to save that I havent been able to sync to my computer with activesync. And like an idiot I overwrote the old file. Is there a solution? I am googling right now to try and figure it out but I am not getting anywhere... TIA
__________________
ATT Fuze
Energy ROM 3.0 60409 Fuze radio 1.14.25.32 
|
|
03-28-2009, 01:11 AM
|
||||
|
||||
|
Re: Reading pim.vol file
Try is see if you are able to open the pim.vol in "notepad"......
Now it will look pretty scramble computter code..but just keep scrolling down...and you will start to make out the number to contacts....I had to do this once...it was a PITA, but it got the job done.
__________________
6700(2nd Backup)-------Kirvin C&S 3.5 WM5 "Still Kicking"
 TouchPro(1st Backup)---Mighty 4.16 / TouchPro2--Big MaxSense 6/9 If you been helped by forum members remember: Don't just say "Thanks"....give 
|
| This post has been thanked 1 times. |
|
03-28-2009, 06:21 PM
|
||||
|
||||
|
Re: Reading pim.vol file
Yep, I see the numbers now. Talk about a pain in the ***! Oh well, I found a few threads while googling that said the same thing. Thanks for the help.
I think I will back up all my contacts in multiple places next time. Last edited by kdj67f; 03-28-2009 at 06:24 PM.
|
 |
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
All times are GMT -4. The time now is 11:19 PM.
