TouchPro 2 Touch screen stops working

[machek]

Originally Posted by p38fln

Well, I finally figured out how this is happening - the digitizer is GLUED on to the phone's plastic case. The glue is like rubber cement, not rigid like super glue. Eventually, the glue lets the screen slide into the center of the phone, until the digitizer actually touches the screen - and then, the digitizer stops working.

It's actually very simple to fix - slide a finger nail under the plastic by the speaker and gently pry the digitizer up. Then, put it back. You dont need to remove it totally from the phone. It will flex back to its flat shape as soon as the glue releases. As soon as you stick it back down, the touch screen will work again.

So you didnt add any glue? You just repositioned it? I got the concave screen thing too, which gives the rainbow look to the screen, and I believe its from overheating as well. how has it worked since?

[neudof]

Originally Posted by machek

So you didnt add any glue? You just repositioned it? I got the concave screen thing too, which gives the rainbow look to the screen, and I believe its from overheating as well. how has it worked since?

I had my slider replaced once for the rainbow thing, and the phone replaced 3 times after that... Refurb, NIB, Refurb.

It is going to keep happening with this type of screen if you cary your phone in your pocket.

[machek]

Originally Posted by neudof

I had my slider replaced once for the rainbow thing, and the phone replaced 3 times after that... Refurb, NIB, Refurb.

It is going to keep happening with this type of screen if you cary your phone in your pocket.

The Problem is i have NEVER carried my phone in my pocket. Its always in a case, and even when i drive, I've had it on the seat rather then on my belt so that the seatbelt doesnt put pressure on it. The only thing i can account for this happening is that the phone got hot while streaming music, and charging it and a few other apps running.

[dadoc04]

THANK YOU SO MUCH!!!! my lil bro was having this issue and its fixed after lifting the digitizer