[UPDATED Added Files] FULL SUCCESS! SuperCID and QPST for NV EFS access

[BorisD]

The Active Sync on the pc? absolutely, otherwise i cant connect to my htc via mtty.

Quick update, i succeed in installing the version touch pro radio, and still get an error.

ill generate the error and some info in a couple of minutes and update the thread.
thanks for all and any help/.

[BorisD]

here is a chain of command ( since i changed the CID before it already is at 00000000 so no changes were needed)

"rtask a
Enter Radio Bootloader
POWER ON PMIC VREG_USB : SUCCESS!
Invalid cmd!...readCID
@CID: 00000000
Cmd>rtask c
Calibration

No card inserted

HTC_SMEM_CE_RADIO_DBG_FLAG:300

Enter Radio Image"

At this point mtty/ Diamond freez... i have to reset the device
now i type in info 8 and get the below

"info 8

--- 2K bytes sector version ---

DEVICE NAME=samsung_k9k2g08
DEVICE ID=0xAA
DEVICE MAKER ID=0xEC
PAGE SIZE=0x800
TOTAL PAGE SIZE=0x840
BLOCK COUNT=0x800
BLOCK PAGE=0x40

Checking block information

BLOCK 10 (0xA) is reversed block
BLOCK 11 (0xB) is reversed block
BLOCK 12 (0xC) is reversed block
BLOCK 13 (0xD) is reversed block
BLOCK 14 (0xE) is reversed block
BLOCK 19 (0x13) is reversed block
BLOCK 20 (0x14) is reversed block
BLOCK 21 (0x15) is reversed block
BLOCK 22 (0x16) is reversed block
BLOCK 23 (0x17) is reversed block
BLOCK 342 (0x156) is bad block
BLOCK 534 (0x216) is bad block
BLOCK 1146 (0x47A) is bad block
Partition[0], type=0x20, start=0x2, total=0x63E
Partition[1], type=0x23, start=0x640, total=0x840
Partition[2], type=0x25, start=0xE80, total=0xD5C0
Partition[3], type=0x4, start=0xE440, total=0x2D640

CE Total Length(with sector info) = 0x7292200
CE CheckSum Length(without sector info) = 0x7220000

Cmd>"


"Cmd>info 7

HTC Integrated Re-Flash Utility, Common Base Version : 1.51d
Device Name: Diamond_C, Bootloader Version : 0.43.CMONEX
Built at: May 16 2008 18:29:36
Copyright (c) 1998-2007 High Tech Computer Corporation

Board ID=0x80
gCurrentPanel=0x1

CPU ID=0x4117B362
AMSS7501A

MicroP-Diam Version : 11
PSOC-Diam STAGE_EVT v20
RAM Size : 128MB"

thanks again for any and all help.

[BorisD]

And in addition, i know this probably shows my lack of understanding, but rtask c puts phones radio on while its in boot loader and activates diagnostic session...

Is this somehow achievable in os under ##3424# and radio on?

sorry for all the questions, just really interested in getting this thing running.
----------

also added nv read for your convenience

[BorisD]

Quick update, tried changing MSL to 000000 and again no luck

[k0rvan]

Originally Posted by BorisD

Quick update, tried changing MSL to 000000 and again no luck

changing the msl with cdmaworkshop its real simple, there are threads on how to doit all over the forum

[BorisD]

Originally Posted by k0rvan

changing the msl with cdmaworkshop its real simple, there are threads on how to doit all over the forum

Sorry i must of not been to clear, i have succeded at changing the msl, however that did not change my outcome when it came to rtask c (nor should it have, but it was a try)

[BorisD]

Here is some more info, so i tried this on my touch pro... exactly the same thing... so i assume telus is affected... did anyone succeed this with telus?

[puff]

Originally Posted by BorisD

Here is some more info, so i tried this on my touch pro... exactly the same thing... so i assume telus is affected... did anyone succeed this with telus?

Juggalo_X has telus, although i'm not sure how much help either of us can be...

i had an issue last nite with MTTY freezing up... until i remember'd to disable activesync...
then it worked flawlessly... this was also on a HTC 6900...

[BorisD]

thanks puff,

unfortunately its no the active sync, i tried on 5 pcs, 2 phones.. sigh

thanks for any and all help.

[yellaboyla]

here is how i did it.

Installed the .47 Bootloader. (really don't know if it matters)

I got my SPC and reset it to all zero's

Put Diamond in DIAG (##diag#)
Connected to diag comm port (mine was 7)
Used CDMA Workshop 2.7 and made sure that i could read write SFC (000000)
Closed CDMA
Opened QPST Configuation and it saw my Comm 7
Opened QPST Explorer from QPST Config
Created 'open sesame door' folder in ROOT
rebooted phone
access to NVM folder.....
no mtty, just easy..........