(WTA)XV6700 screen alignment always change

[foakgul]

Originally Posted by psiphi

There is another thread on this (search on digitizer) but one possible solution is to carefully take a sheet of paper and clean the lint between the case and the screen, being careful not to get it stuck around the corners... This solved my problem for a long time (until I droped the PDA and the top half of my screen was permanently mis-alligned... Thank you Sprint for TEP )

Good Luck...

Guys I tried psiphi's solution and it works!! Thanks psiphi! MY ppc6700 was always going out of alignment especially on the right side so I cleaned the right side with a thin sheet of paper under the plastic. A good explanation for that maybe that, if dirt gets stuck in there, it will force your screen downward at the right side and the actual contact of the screen will take place at an offset position rather than the intended position.

[ferky]

Thanks you all guys
Now my alignment goes well..
So far i conclude that the buildup under the front case was the source of the miss alignment issue.
Once again Thanks
PROBLEM SOLVED

[GaMedic]

Originally Posted by ferky

Thanks you all guys
Now my alignment goes well..
So far i conclude that the buildup under the front case was the source of the miss alignment issue.
Once again Thanks
PROBLEM SOLVED

That worked for me too. No more issues. I folded the paper into a point and cleaned the corners which completely eliminated my problem.