1.43 radio - Page 2

Schwartz · #1 (**permalink**) 10-19-2007, 01:22 PM

Quote:

Originally Posted by sfld

im running kirvins clean and simple plus.... and when i try to upgrade the radio from 1.41 to 1.43 it says error 120 invalid country? or something similar to that.

You are running vista arent you.

Dane

sfld · #2 (**permalink**) 10-19-2007, 01:28 PM

nah im running windows xp prof.... kinda weird right?

shakuyi · #3 (**permalink**) 10-18-2007, 04:27 PM

is this only for verizon or works on sprint too?

KidGixxer · #4 (**permalink**) 10-18-2007, 04:36 PM

Quote:

Originally Posted by shakuyi

is this only for verizon or works on sprint too?

It should, We've been using sprint and altel versions so far.

d_phekt · #5 (**permalink**) 10-18-2007, 11:34 PM

Quote:

Originally Posted by shakuyi

is this only for verizon or works on sprint too?

i have sprint running WM6 and when i tried to install i got an error stating it is not intended for use on my device.

**Torx** · #6 (**permalink**) 10-18-2007, 04:45 PM

imma let this thread simmer a little before giving this a try.

**weedahoe** · #7 (**permalink**) 10-19-2007, 02:29 PM

Quote:

Originally Posted by Torx

imma let this thread simmer a little before giving this a try.

Im with you on this one

everburg · #8 (**permalink**) 10-19-2007, 02:35 PM

I couldn't use the ROMUpgradeUT.exe utility included with the 1.43 radio. I copied and pasted the 1.43 radio (radio_.nbf) into the "NoID_RUU" folder in one of Helmi's Kitchens under the folder "Upgrade" and it worked for me. I also did a soft reset only after updating and everything worked.

quadz24 · #9 (**permalink**) 10-19-2007, 05:50 PM

I aslo used the way Everburg suggusted for my Sprint PPC6700. I used the Helmi_APAC_Official_AKU3.5_Kitchen_1.0.4 and extracted the folder \Upgrade\NoID_RUU and placed the Radio_.nbf file into the folder. Put my PPC6700 in bootloader mode and I ran the radio update by running the APACUpgradeUt_noID.exe command. after the update completed i did not do the hard reset. I just did a soft reset and the radio has been working fine. I have not tested the radio anywhere but here at work but i do have a 1-2 extra bars on the signal meter.

Silent_Patriot · #10 (**permalink**) 10-19-2007, 06:32 PM

Ran Internet Sharing on it all day as well as a couple of calls on my XV6700 with VerizonGuy's WM6 Alpha4.

Used the Phoenx06_Radio_1.41 tool that came out after the BM AKU 3.3 and just extracted the radio.nbf in place of the old one. I did hard boot and had to set everything up again, but I always do when flashing.

Noticed an extra bar (3 instead of 2) without the external antenna that I run at my desk. Been getting 4 solid bars since 1.41 w/antenna, so all I can say is that my download speed seemed to stay higher (between 1-2mb/s) all day, whereas before it would drop under 1 more often when traffic increased on the network later in the day.