Treo Pro CDMA HardSPL

[Major_Nate]

Freakin Schweet! Thank you so much! **MUAHAHAHAHA** **Does happy dance**

[treopro408]

I had to do the Manual Install the SSPL-Manual-PantherCDMA. When I reboot I get the following on the SPL unlock screen

PANT200 MFG
SPL-0.32.SSPL
CPLD-2

Is this correct?

[Malatesta]

Originally Posted by treopro408

I had to do the Manual Install the SSPL-Manual-PantherCDMA. When I reboot I get the following on the SPL unlock screen

PANT200 MFG
SPL-0.32.SSPL
CPLD-2

Is this correct?

yup, that's the boot loader

[MordyT]

Originally Posted by CFay

Of the unlocker?

yeah...
i know. just download it and run it. and take a screenshot.

[omfgaturtle]

I think i have a problem.
I have, after installing the .exe and running it fully, even having the bar go to 100% it still will not change to .36 CMONEX it stays at .32

I have unlocked may devices including a touch pro and titan and i know im doing it properly. I am simply stumped.

Any help?

I am thoroughly confused.

[JCSands]

Don't know if this is what is going on or not, however I had that same issue when I was trying to update using the front USB port on my desktop. I finally gave up, frustrated, and tried one more time using a USB port on my laptop, and it worked fine. So, I wonder if maybe the USB port on my desktop was bad or wonky.

[chrisjh18]

Originally Posted by omfgaturtle

I think i have a problem.
I have, after installing the .exe and running it fully, even having the bar go to 100% it still will not change to .36 CMONEX it stays at .32

I have unlocked may devices including a touch pro and titan and i know im doing it properly. I am simply stumped.

Any help?

I am thoroughly confused.

Had the same problem man... This is where I was going wrong though. After it would finish unlocking, instead of pressing Camera + Power + Soft Reset to go to Bootloader I was using the SSPL-Manual-PantherCDMA.zip file. When using that file it showed the .32 SSPL like yours did, but once I press the buttons to enter bootloader it showed .36 CMONEX like it's supposed to.

So as long as it went through 100% it should be good, press Camera, Power, and Soft Reset to make absolutely sure though.

Almost forgot.. to cmonex and cfay:

THANK YOU

[Eggroll822]

just donated thanks much!

Updated fine after I read that you should disconnect then connect when on the tricolor screen if it gives you trouble.

[RKnight]

Ok I am stuck here I cant get this to unlock my wifes phone. I can get to the boot loader and it shows:
PANT200
SPL-0.38.0000
CPLD-2
when ever I try to unlock it doesnt work. When i try from the laptop it says "Please make sure the device is properly synced; Please retry after syncing the device (via Activesync or Windows Mobile Device Center)"
And then mentions the cab to download which I did and then installed it to the device. I have tried the method from the phone as well and still no sucess. I have even tried all 4 USB ports on my laptop. I am familiar to unlocking and flashing custom ROMS with my Touch Pro so its not like I dont know what I am talking about here. Any advice here will be great because I want my wife to enjoy WM6.5.1 like I do.

[ahvl]

Cmonex,

Any chance of Pro GSM Hard-SPL? Please!!!
I am jealous with Pro-CDMA people.