[SIM-UNLOCKER] - -RhodiumW/Sprint/Verizon/Telus Touch Pro 2 CID/Security/SIM Unlocker

[jj62mtp]

Originally Posted by xicloe

My touch pro 2 verizon is already unlocked, and use the energy Rom, what if I want to reflash another Roms, did I'll make my Phone is Locked again or the unlocked is permanent ?

btw, I am in Asia right now.

Originally Posted by jocampo86

if i flash another rom would i loose the unlocker

The unlocker is permanent. a rom flash will NOT undo it.

[xicloe]

thanks for the answer

[jrmatics]

i just ran this program and everything works great. i can now use my t mobile sim in my sprint touch pro 2. initially i had to manually change setting to t mobile, it registered, and after that everything runs automatically in global mode. great. i completely skipped the sprint thread and installed the 2.32.00wu radio and presto. all of u geeks here are freakin fantastic=D>

[Jays4Life]

Originally Posted by bigchico67

so I tried to flash the sprint radio patch before the security unlock, yes I know I don't know what I was thinking, I wasn't paying attention. Anyways now I am stuck on bootloader screen and hard reset wont fix it, what do I do???

I'm in the same situation

I tried what was said on page 2 which is reflash a rom on there, but obviously if it's stuck on the multicolor screen, I cant sync to WMDC, therefore mightyrom won't find it.

HELP ME PLEASE

[Dr.8820]

run the re-locker, it will boot back up.

[Jays4Life]

Originally Posted by Dr.8820

run the re-locker, it will boot back up.

I apologize for my severe PPC ignorance, but how do I relock? And where would I find the software?

I used the search function with no luck

[Jays4Life]

Total shot in the dark but i'm guessing you meant the stock rom?

If that's what we're talking about, it finds the phone, under image info it shows nothing, it continues on to the "%" screen but never progresses anything past 0.

In the meantime the phone just cycles between the bootloader screen and the black screen.

And here I thought this was going to be easy

All help is appreciated folks =/

[Jays4Life]

I found the Rhodium re-locker, but here's my new issue

This phone doesn't stay "connected to the PC. It will start with a black screen, then after maybe 20 seconds show the bootloader color screen. Once "USB" shows up in the grey portion of the screen, it then "disconnects" from the computer and the screen goes blank again. Over and over...

I tried getting the SendEndPower to work before connecting to the computer, but the bootloader won't show if I do it that way. If it's not connected to a power source it doesn't do squat.

I'm about ready to rip my hair out

[Dr.8820]

Originally Posted by Jays4Life

I apologize for my severe PPC ignorance, but how do I relock? And where would I find the software?

I used the search function with no luck

the re-locker is located here http://forum.ppcgeeks.com/showpost.p...12&postcount=2. usually what i do is check my connection after each step, try that. report back if you need more help .

[evertec]

hmm, so I successfully ran the program and unlocked but it didn't seem to do anything. I still can't get an At&T signal... just says searching, then no service. The manual selection doesn't find anything either. Any ideas?