unlock, flash and even relock your TP via the SD card!

[cornelious2]

Originally Posted by razorloves

Good point cornelious. I was just relaying the instructions from the first post. He will be fine if he just uses the nbh from the shipped rom. It will only have a possibility of relocking if he ran the exe file while connected through activesync.

im not so sure about the not relocking part since i relock my tp via sd like a normal flash using the shipped sprint nbh

[razorloves]

Originally Posted by cornelious2

im not so sure about the not relocking part since i relock my tp via sd like a normal flash using the shipped sprint nbh

I've never seen that behavior on the sprint touch pro's I've flashed with the shipped rom, both the exe or just the nbh. Even ImCoKeMaN said that cmonex and olipro made the hardspl to where it couldn't be overwritten. I did see another guy over there is saying the same thing as you though. You may have already read up on it but if not it's discussed over on page 7 of the stock roms thread. Which sprint shipped rom are you using when it relocks your phone?

[inkjammer]

well I am stuck in the loop also no errors just have to push power button and it goes to tri color screen then it loads up bar and goes to tri color and I have to push power button and then it goes back to bootloader screen. I have been reading post it says just flash any rom and it will quit so how do I flash it when it is not synced to computer?

[inkjammer]

I did the rename thing and it worked thanks so much everyone and when I get paid I will be leaving a donation for you guys

[Beejis]

Originally Posted by inkjammer

well I am stuck in the loop also no errors just have to push power button and it goes to tri color screen then it loads up bar and goes to tri color and I have to push power button and then it goes back to bootloader screen. I have been reading post it says just flash any rom and it will quit so how do I flash it when it is not synced to computer?

I for some reason can't flash via the SD card anymore, but what I did was get a memory card reader, insert it into my computer or printer (however my computer can see it) then put a RAPHIMG.nbh file onto it that route and try and flash again. Hope that helps!