[Android Froyo][CyanogenMod6-Ports by Neopeek]

[m4f1050]

OP what ROM do you recommend flashing? Any minimal ROM out there?

[arrrghhh]

Originally Posted by m4f1050

OP what ROM do you recommend flashing? Any minimal ROM out there?

If you read his posts, there isn't an Android ROM ready for your device... This is just like any of the other builds, it depends on your SD card - but it also requires an ext2 partition on your SD, so it's a little trickier...

[m4f1050]

Originally Posted by arrrghhh

If you read his posts, there isn't an Android ROM ready for your device... This is just like any of the other builds, it depends on your SD card - but it also requires an ext2 partition on your SD, so it's a little trickier...

Yeah, I was asking a minimal (smaller) WM ROM to flash on device. I already have done the ext2 partitioning on SDCard before (using Paragon)

[arrrghhh]

Originally Posted by m4f1050

Yeah, I was asking a minimal (smaller) WM ROM to flash on device. I already have done the ext2 partitioning on SDCard before (using Paragon)

Oy. There's been a lot of discussion on this as well... Again, it's OT but from all the testing I've done, the WinMo ROM has absolutely no effect on Android performance.

[Asphyx]

Well EPIC FAIL on my attempts to install any of the Android releases onto my TP.

I have done all the steps for the startups (both in NK and Haret) and I even created the EXT2 and SWP partitions but each time I try to install I get the Booting Linux screen and then the Phone Locks up.

Not using overclock or anything like that.

I will keep trying and see what I come up with but does anyone have any short list of common mistakes that can lead to the phone booting linux and then locking up? I know the phone is supposed to reset and it should take quite a while to install the files (I have given 20 minutes on many attempts) but the phone just locks up.

Specs:
VZW TP
8GB SanDisk TransFlash
512 MB EXT2 Partition (set as Primary)
64 MB SWP Partition
Remainder is Fat32 and is the first Partition created on the card.

I will play a little more since this does not seem to affect the Phone from booting into Windows but any help or hints on something I may have missed would be helpful.

NOTE: it is not just this release it happens on every release I have tried so other users should not think this is a problem with the package that is released, It is definitly User Error on my part, just can't figure out what I'm missing.

Found out the problem was using Raph800 and I have a 500! Finally got it to boot, will report on how well it works later!