FINAL | 11-30 | ROM | WM 6.5 | TF3D 2.1 || GadgetROM v2.00 || 21874

[Procter]

Before going to new release, could you figure out the PRL uprade not working problem in v1.95? Or anyone could provide a solution? Thanks.

[mwalt2]

Originally Posted by Procter

Before going to new release, could you figure out the PRL uprade not working problem in v1.95? Or anyone could provide a solution? Thanks.

You can update manually in thread below:
http://forum.ppcgeeks.com/showthread.php?t=95986

[gadgetfreak]

Originally Posted by Procter

Before going to new release, could you figure out the PRL uprade not working problem in v1.95? Or anyone could provide a solution? Thanks.

I'm going to check with some other chefs on this, but I suspect their may be an incompatability problem with the applet, and either TF3D 2.1, or more likely 238xx+ sys. Remember, the update PRL & Update Profile applets were written for 6.1, so it shouldn't come as a surprise that it stopped working. Or it could be that I'm an idiot and goofed somewhere...

[KBZL]

Originally Posted by gadgetfreak

I'm going to check with some other chefs on this, but I suspect their may be an incompatability problem with the applet, and either TF3D 2.1, or more likely 238xx+ sys. Remember, the update PRL & Update Profile applets were written for 6.1, so it shouldn't come as a surprise that it stopped working. Or it could be that I'm an idiot and goofed somewhere...

Im running 6.5 21876 and my update prl worked fine. I had an issue a week ago where it didnt but i did a soft reset and tried again and it worked.

[mwalt2]

Originally Posted by gadgetfreak

I'm going to check with some other chefs on this, but I suspect their may be an incompatability problem with the applet, and either TF3D 2.1, or more likely 238xx+ sys. Remember, the update PRL & Update Profile applets were written for 6.1, so it shouldn't come as a surprise that it stopped working. Or it could be that I'm an idiot and goofed somewhere...

I'm also using COM2 builds and PRL is updating ok for me.