Trying to update radio and cant!! Please help!

[batman31]

I received a new touch from sprint after my last one stopped working and I loaded the 2.31 unlocker (succesfully shows 4 color screen with spl 2.31 coke) but everytime I try and load the new radio (all tel 3.37) it gets stuck at 11%??

Have been doing this all night.. AnY HELP??? PLEASE??

[xttc2000]

don't the instructions clearly state that it looks like it hangs up at 11%?
Give it a few minutes, it should continue updating.

[batman31]

I keep getting a disconnection error. At 11% I get the dreaded error message that the pc and phone have stopped communicating???

Please help.. I am stuck

[batman31]

Anyone out there help me on this one???

I reset the locker to spl-0.36 on the tricolor screen while also reloading the original factory sprint rom.

Now I go to the 2.31 unlocker and it goes fine...

But still when I try and load the alltel rom radio it not only freezes at 11% but the connection stops and I get an error in the rom upgrade utility?

COuld I upgrade the radio from the memory card? Would this make a difference?

Anyone?

[Brock1909]

after you get the error message, do you disconnect the phone or let it run? because if you leave it on there after it disconnects at 11% it will reconnet and continue the DL ( at least that is what mine did)

[boggsie]

Originally Posted by batman31

I received a new touch from sprint after my last one stopped working and I loaded the 2.31 unlocker (succesfully shows 4 color screen with spl 2.31 coke) but everytime I try and load the new radio (all tel 3.37) it gets stuck at 11%??

Have been doing this all night.. AnY HELP??? PLEASE??

Are you a Sprint or an Altell subscriber? If Sprint, then go ahead and load the full 3.02 leaked Sprint ROM, which includes an updated radio, too.

The leaked rom is available in this post:

http://forum.ppcgeeks.com/showpost.p...38&postcount=1

[Spencer_Moore]

are you on a mac running paralells? i ahd the same problem when i tried it doing that

[Soul_Est]

Originally Posted by Spencer_Moore

are you on a mac running paralells? i ahd the same problem when i tried it doing that

@Spencer_Moore

I think trying it in VirtualBox would have worked out better. At least that's what I used on my Mac.

[Spencer_Moore]

I use vmware fusion and it works perfectly but i also had the problem of it getting stuck at 11% with parralels desktop. I was asking to help the other perosn because it sounds like he is having the same problem i was wheni first got my touch.