Cannot get RUU to install the Titan Radio! - Page 2

YukonJack · #11 (**permalink**) 06-25-2009, 10:26 PM

Alright 2.40 installed and rebooting properly now.

ayato · #12 (**permalink**) 06-25-2009, 10:26 PM

If you successfully get your spl updated to 2.40, you may still be stuck at your bootloader screen. At this point you should be able to update to your new radio. Just run the RUU as you did before. My guess is that the radio was not compatible with the older SPL

ayato · #13 (**permalink**) 06-25-2009, 10:27 PM

Great!!! Is everything as it should be?

YukonJack · #14 (**permalink**) 06-25-2009, 10:28 PM

Forgive me. But can you walk me through the ruu again? I have the RUU folder and I have a Titan Radio ROM (3.42.50). do I just put the radio (extracted) into the RUU folder?

ayato · #15 (**permalink**) 06-25-2009, 10:31 PM

The file should end in .nbh....Name the file to be Ruu_signed.nbh and put that in the RUU folder and run the RUU.

YukonJack · #16 (**permalink**) 06-25-2009, 10:38 PM

Hmmm. When I do that, I get ERROR 328 Invalid Command. This update Utility cannot be used for your PDA Phone. Please check your update utility.

Any ideas?

ayato · #17 (**permalink**) 06-25-2009, 10:40 PM

What radio are you trying to use. Where did you get it?

YukonJack · #18 (**permalink**) 06-25-2009, 10:41 PM

Titan Radio ROM 3.42.50 from the guide download link.

YukonJack · #19 (**permalink**) 06-25-2009, 10:50 PM

I think I am going to can it for the nite. The phone is at least not bricked

and I have access to a card reader tomorrow that I can try to flash the proper radio with. Thanks for the help, I will check in here tomorrow and see what is happenning. Thanks a bunch again.

Greg

ayato · #20 (**permalink**) 06-25-2009, 10:51 PM

Hmm....and what is the file named when you extract it?