Epic 4G One Click Root & ClockworkMod [RFS & EXT4]

[gTen]

Originally Posted by CozBoogie

I have tried the one-click root on 2 PC's and 2 Macs....and I have struck out every time. I've posted my results in another thread before the re-org of the Galaxy S forums so I won't re-post everything but on the PC's I get this:



and on the Macs I get a "bus error".

Thoughts?

late,
Coz

on pc are you on a win7/vista..if so are you running it as administrator?

Edit: Just looked at previous thread and saw you got XP..

lets try this...

go into command prompt..and type the following replacing ([PATH] with the path to where you extracted the 1 click root)

SET PATH=%PATH%[PATH]

Then run it.

[CozBoogie]

Thanks for the input gTen. I tried your suggestions but my result was basically the same thing. When I ran the one-click again I would get "no device found" message....so I'm thinking there must be some issue with the samsung's drivers not fully loading on either of the PC's (both running XP/32).

I repeatedly uninstalled/installed the driver but continued to get the same result. I do have admin privileges so I'm not sure what's going on.

I'll keep messing with it though.

late,
Coz

[gTen]

Originally Posted by CozBoogie

Thanks for the input gTen. I tried your suggestions but my result was basically the same thing. When I ran the one-click again I would get "no device found" message....so I'm thinking there must be some issue with the samsung's drivers not fully loading on either of the PC's (both running XP/32).

I repeatedly uninstalled/installed the driver but continued to get the same result. I do have admin privileges so I'm not sure what's going on.

I'll keep messing with it though.

late,
Coz

The no-device found is progress..that means ADB is running..now one thing, when you uninstall the drivers and install them back then plug it in..do you have 3/4 usb drivers finish loading on your system? (you can see them in the right corner usually when installing or in device manager)..also on yoru device there is an icon that its runnign in debug mode when you plug in right?

[CozBoogie]

Holy shit....well this has been a near week long effort but I finally got this mother rooted. I did the "path" trick here on my work computer and it finally took!!!

Thanks gTen and everyone else who chimed in.

late,
Coz

[gTen]

Originally Posted by CozBoogie

Holy shit....well this has been a near week long effort but I finally got this mother rooted. I did the "path" trick here on my work computer and it finally took!!!

Thanks gTen and everyone else who chimed in.

late,
Coz

No problemo

For reference if anyone in future gets the above issues:

The first issue most likely happened because when you ran it normally unlike running in command prompt depending on the configuration defaults to your home path rather then the actual path your in. So either running it directly in cmd prompt from the dir or changing the ENV path variable makes it work.

The 2nd issue is caused by drivers not fully loaded once you plug in the device or debug mode not enabled.

[CozBoogie]

Downloaded SDX Stock App Removal and cleared out all that Sprint crap.

Thanks again for the help.

late,
Coz

[revaaron]

{"error": "Invalid access attempt for this token"}

[gTen]

Originally Posted by revaaron

{"error": "Invalid access attempt for this token"}

I think its a thing with Google chrome..check out the WIKI sticky thread for direct links

[revaaron]

I'm using firefox.

[gTen]

Originally Posted by revaaron

I'm using firefox.

well either way on the wiki are direct links that should work fine.