Zagg Invisible shield real world review

[j32driver]

Hi Kids!

I just got the Zagg full body shield installed on 2 Omnia's and thought everyone might enjoy a real world perspective.

Overall: I'm pretty happy with the product. Its got a good sticky feel to the phone now, and the screen works just as good now, if not better than before. It's not difficult to install, but its not idiot proof either (note back of phone).

Install tips: Clean your hands with soap and water to remove any oils from your fingertips. Wipe down phone with a moist microfiber towel to remove any and all grime from it. When peeling the plastic pieces, I found it easiest to start a corner, then spray my fingers with the solution, then peel the plastic completely off. USE PLENTY OF SOLUTION. More is better than less. The small pieces go on easier than the big pieces. The bends settle in after about 5 minutes. The front and back are the most difficult. Start with only one edge down, and then squeegee the big piece down as you go.

One big problem: The screen protector isn't cut correctly for the front camera. The hole is present, its just in the wrong position. (See pics below).

Hope everyone find this helpful. Oh yeah... these pictures are from 12 hours after install. I've been told by others that it will look quite a bit better after 3-5 days have gone by.