To Bell VIA Cloning...A P3050 to a MP6900

[dave68]

I droppedd my phone, and it smashed the power button in. So I bought a replacement (P3050 VOGU100 Telus) from the Internet for less than it would cost to repair it ($80.00.) So I proceeded with the clone (sucessfully I might add, save one major glitch, I can't connect to the internet: see here http://www.mobile-files.com/forum/sh...t=68879&page=9 ) I have used the Alltel radio/rom on my busted phone, and the internet works there. I have changed the E$N and the PRL, and MNID, and MSID, etc. Phone will pass the *2255 test call. "EV" is present at the top. IM works, phone works, GPS works, just not internet. On this phone (from Telus) it dials #777 Then asks for User name / Password / Domain. Bell Tech Support says that should all be left blank. But I've even tried
Domain: 1X.bell.ca
NAI: 780xxxxxxx@1X.bell.ca
Pass they gave me was xxxx (even tried my pass. nogo.)
But it rejects it, with either user/ pass incorrect or "failed for an unkniwn reason." I looked in the registry of both phones, and ##data<SEND> don't work. and the other phone says that all addresses should be obtained automatically... I concur.
I tried a STATIC IP 206.47.78.149
Nogo. Pinto. Any suggestions?
BTW: I tried a Hard reset, to no avail. I haven't tried flashing it again tho...

[gilngeek]

try 780xxxxxxx@mip.1x.bell.ca

Originally Posted by dave68

I droppedd my phone, and it smashed the power button in. So I bought a replacement (P3050 VOGU100 Telus) from the Internet for less than it would cost to repair it ($80.00.) So I proceeded with the clone (sucessfully I might add, save one major glitch, I can't connect to the internet: see here http://www.mobile-files.com/forum/sh...t=68879&page=9 ) I have used the Alltel radio/rom on my busted phone, and the internet works there. I have changed the E$N and the PRL, and MNID, and MSID, etc. Phone will pass the *2255 test call. "EV" is present at the top. IM works, phone works, GPS works, just not internet. On this phone (from Telus) it dials #777 Then asks for User name / Password / Domain. Bell Tech Support says that should all be left blank. But I've even tried
Domain: 1X.bell.ca
NAI: 780xxxxxxx@1X.bell.ca
Pass they gave me was xxxx (even tried my pass. nogo.)
But it rejects it, with either user/ pass incorrect or "failed for an unkniwn reason." I looked in the registry of both phones, and ##data<SEND> don't work. and the other phone says that all addresses should be obtained automatically... I concur.
I tried a STATIC IP 206.47.78.149
Nogo. Pinto. Any suggestions?
BTW: I tried a Hard reset, to no avail. I haven't tried flashing it again tho...

[dave68]

Nope... I think I missed the three seconds before Altell's connection specific stuff was put on it... Flash again with the Bell WM6.1 rom? Will that change settings or am I screwed?