wouldn't it be cool

knewBee4lyfe · #1 (**permalink**) 05-21-2009, 06:06 AM

i have this great Idea...

i want to make sure there would be some people who would buy this product before i decide to start making it... or research it.

and its a cell phone holder...

it would need to be shallow so we can slide open the phone...

and it would have a built in usbplug... for 2 reasons...

first is that it can just be plugged in while its in the holder... second would be for the built in mini fan so if you're using the more than just the text messaging function it would work. maybe... but i doubt it... i will install the output plugs... but again... i highly doubt it.

but for sure... make a heatsink... backing... just like the normal backing but w/ 2 in long little metal heatsinks on each side of the camera... yea... it will prolly make the phone thicker by atleast an eighth of an inch but it will help keep the phone cool when its being used for gps... internet... streaming music to the car... and it will not stop charging.

better if it was plugged into the vent or near the a/c vent.

i thought about the heating core vs the cold air. and i was a little worried about moisture... or dew-ing like on the side of a can... don't know if that will occur w/ this set up.

well... i don't know how to get it started but ... wouldnt it be cool...

i even have drawings or blueprints in my head. ill try and draw it... but all im working w/ is ms paint. lol

LoneSnark · #2 (**permalink**) 05-21-2009, 09:45 AM

I would call it overkill. But if you want a good heatsink you would need to do more than just replace the back. Cut the plastic away over the processor/radios so the metal heatsink can directly contact the heat producers. That by itself would work significantly better than the default setup, so you would not need fins.

knewBee4lyfe · #3 (**permalink**) 05-24-2009, 04:27 PM

yea... but then i wanted it to be more like a doof can buy it and put it together. and not have to void thier warranty...

madcook · #4 (**permalink**) 05-24-2009, 04:36 PM

im sure you would get a few people to buy but i dont know if its enough to off set the cost to make it . so maybe a poll start a site talking bout it show blue prints ,ask people to leave a comment or counter of some sort to get an idea how many folks would buy it just some thoughts not to burst your bubble

BigDiesel07 · #5 (**permalink**) 05-24-2009, 06:36 PM

Interesting idea... You can go here for pictures of how the Touch Pro looks like naked...