Voice command not completing call

[jkhawk]

I can use my jawbone to initiate a call through voice command by dialing a number. That works fine.

But when I say the person's name the voice command get's stuck on the last step. You can even see the screen change to the person's name and then it just stops and nothing happens. This happens with every contact when I dial by voice command. But like I said if I dial by number it goes through.

Has anyone had this happen or know a solution? Spent an hour on phone with Sprint tech support and they had no answers.

[helix139]

Ahh, more Widcomm stack fun. The problem is the audio channel is extremely slow to open. Thus, when it asks you for confirmation, you need to wait for the channel to re-open, which doesn't happen until the little microphone appears in the taskbar again, about the same time the contact page pops up. If you wait about a second or two before speaking after VC asks for confirmation, it should work properly.

[jkhawk]

Thank you very much. It worked...although much slower than past phones. Long time lurker here and rarely post but have had 6700, Mogul, and TP. I searched and found no luck.

My next question is, is there a tweak to speed it up so it doesn't react so slow? Thanks in advance.

[drurc8]

I think we still have problem between VC and TP2 bluetooth stack until someone can unlock the phone so we can use other rom or kitchen rom and hoping that it solves the problem.