how do u clean the sticky side of a screen protector?

sfetaz · #1 (**permalink**) 09-27-2009, 04:01 AM

Wirelessly posted (XV6875 Opera/9.50 (Windows NT 5.1; U; en))

I have a ghost armor screen protector. The sticky side has gotten dirty to where I cannot apply it again to my tp2 because its not totally see thru. I tried applying tape to the sticky side and peeling but it is still dirty. How do u clean the screen protector so when applied its completly see thru?

**Dragon2** · #2 (**permalink**) 09-27-2009, 05:17 AM

soap and water maybe.

bstan · #3 (**permalink**) 09-27-2009, 07:35 AM

I had exactly the same problem with my Ghost Armor. I sent them an email and didn't get a response. The solution I found was pretty easy though, order a different screen protector.

1454 · #4 (**permalink**) 09-27-2009, 08:13 PM

The solution I have used before is to run luke warm water over the sticky side and LIGHTLY, I can't emphasize enough lightly, rub with your finger. Make sure you wash your hands really good before doing this. Hope this helps.

Exil3d · #5 (**permalink**) 09-27-2009, 08:16 PM

My technique is simple and effective. Dish soap and water. Apply dish soap on the sticky side and apply on your hands too. Then just massage it under running water and after a minute of rinsing you have a nice clean ready to go on protector. I always do it early morning and inside a steamy bathroom. Keeps the lint off.