How to get bubbles out when putting on screen protector?

[slizzap]

Man there's some funny responses here haha. The main trick to no air bubbles is to make sure you don't get any dust between the screen and the protector when you're applying it. The magic solution? Can of compressed air.

1) Take the screen protector and wash it lightly in the sink with whatever soap you have and gently wash it just to get any particles off it. Then sit it flat, screen-side up, on a paper towel.

2) Use Windex or whatever to clean your screen to your liking.

3) Use the can of compressed air to blow dry the protector. This should take ~15 seconds. Just blow the water bubbles off onto the paper towel.

4) Use the can of compressed air to blow any dust off the screen.

- Repeat steps 3 and 4 as necessary. I'm anal and super picky about bubbles so I used a lot of air to ensure there was no dust.

5) Line up the screen protector at the top of the phone and just drop it into place. It should perfectly adhere to the screen with not a single bubble.

Works like a charm every time. That whole process took me maybe 2-3 minutes. No need to wait for the shower to steam up your bathroom