tried everything, still stuck on splash screen

[supermaxkato]

TP2 I can get into bootloader just fine and have flashed 5 different stock roms (2 shipped and MR1-3). All reach 100% successfully, but after that I get the splash screen for 30 seconds, and then the never-ending reboot begins.

I've tried all of the following without success:
-flashing different stock roms (as mentioned)
-giving the battery a separate charge
-leaving the battery out overnight
-MTTY "boot" command
-MTTY "Task 8" command

When I try to go back to hardspl it just sits at 0%.
I do the believe the problem is the last NV write I did.
I backed up my original though, so if there was a way to copy it back on the phone, it might fix the problem. But QPST needs me in DIAG mode to communicate (same with CDMA).

So I'm looking for any ideas that aren't easily located with Google (I'm close to 6 hours of searching over the past week with no luck).

*If someone can tell me how to use MTTY (or any other program that can communicate with the spl bootloader) to copy NV items, then it might be the fix I need.

No need to post that it's "bricked". Given it's ability to go into bootloader and work with MTTY I can't believe that to be the case. And no warranty for me, so sending it in is not an option.

Thanks for supporting this community (and helping guys like me out).

[supermaxkato]

Thanks Horndoctor.
I will give anything a try. But I did re-lock before flashing the stock roms.
Can you post or give me a link to a Verizon radio (the stickied ones here are all dead).

Also,
I am Sim/CID unlocked with Olipro's purchased unlocker, and have his unlocked radio from his post (WU version) too.

If I can get a locked radio I will try that.

Anyone else have other suggestions?