most basic ROM

[ulysses]

Originally Posted by PPCFreak

Are you setting up a TP2 to be a remote car starter????

why yes i am.....

i'm still looking for a super lite ROM though... loooonnnggggg bat life, EVERYTHING except sms and phone STRIPPED... then i'm planning to set it where it'll play a ringtone when ONLY my number txts it.
i'd like to have a cable plugged in the headphone jack..
then.... (if all goes to plan since i don't have much experience with 555timers, yet), the 555 circuit will send a signal to my second FOB to "lock", and after a second or two, another signal to "start".....
i currently have "12.08.10.NackedNeo-21914" installed. i couldn't find the genY rom.





-u

[kozmo]

Originally Posted by ulysses

why yes i am.....

i'm still looking for a super lite ROM though... loooonnnggggg bat life, EVERYTHING except sms and phone STRIPPED... then i'm planning to set it where it'll play a ringtone when ONLY my number txts it.
i'd like to have a cable plugged in the headphone jack..
then.... (if all goes to plan since i don't have much experience with 555timers, yet), the 555 circuit will send a signal to my second FOB to "lock", and after a second or two, another signal to "start".....
i currently have "12.08.10.NackedNeo-21914" installed. i couldn't find the genY rom.





-u

HERE are Calkulins Gen Y stripped ROM's... about as basic as it gets

[PPCFreak]

Your think this too hard.

Couple of others have done this already but using the power wires from the vibration motor to trigger the start signal.

Remote Start using Cell Phone: Part 1 | Dave Hacks

See link above.

I currently have an apache phone I was looking at doing this with but am planning to go the paid cell route and modify the way the link above talks.

Couple of issues I see with this: Need a method to authenticate the signal to start (if using SMS, any sms from any cell phone would trigger the vibrator in the phone, thus sending start signal). Using a DUMB phone would make this harder.
Using a smart phone (Apache was my thought) would allow custom code to setup the authentication code (SMS with CERTAIN text), or better option would be an REPLY from the Apache to the sending device asking ARE YOU SURE....

Just my thoughts out loud.

EDIT: Doing the door locks might be harder....doing the door locks in conjunction with the start should be a option of the remote starter so should be okay.
But door locks by themselves would be a lot more difficult, if using ONLY the vibrator motor wires from the cellphone/smartphone.

Again thoughts out loud.