Help! im stuck on the green red & black screen

mellymelly · #1 (**permalink**) 12-27-2009, 03:34 AM

My phone just freezes on the colorful screen when trying to load roms. What am I doing wrong?

InsomniacJedi · #2 (**permalink**) 12-27-2009, 03:55 AM

First off, stay calm.

Second, what did you do to the phone? Have you flashed a custom ROM? Did you unlock it?

Jalupinja · #3 (**permalink**) 12-27-2009, 07:51 AM

Quote:

Originally Posted by InsomniacJedi

First off, stay calm.

Second, what did you do to the phone? Have you flashed a custom ROM? Did you unlock it?

What this guy said!!!

Also you have a sprint TP2 which means you have a CDMA phone so anything you flash "has to be the CDMA version" or you may BRICK it!!!

**jshaas2** · #4 (**permalink**) 12-27-2009, 10:22 AM

This happened yesterday. a guy hurried too quick, probably didn't read instruction correctly and flashed a GSM radio that is known for bricking. Hopefully, this didn't happen.

joeramirez · #5 (**permalink**) 12-27-2009, 12:57 PM

I wasn't the one spoken of yesterday, but I also "bricked" my phone by flashing a GSM rom. I am happy to say that after 3 hours of research and the suggestions given to the Basic Training kid was able to fix it. I loaded a bootloader program from one of the VIP posters in the other thread. Found it in his signature and then downloaded the original rom and after several hits and misses was able to flash the stock rom and then back to Mighty Rom .

**aznmode** · #6 (**permalink**) 12-27-2009, 01:20 PM

try just loading the stock rom first. if it was just a bad CDMA flash that should fix it.

mellymelly · #7 (**permalink**) 12-27-2009, 02:29 PM

all i did was load the hrd spl for my sprint htc pro 2. and it says that its installed but it never gets pass that colorful screen stage but when i hit the reset button it goes back to functional mode like it originally was

Jalupinja · #8 (**permalink**) 12-30-2009, 05:06 AM

Quote:

Originally Posted by mellymelly

all i did was load the hrd spl for my sprint htc pro 2. and it says that its installed but it never gets pass that colorful screen stage but when i hit the reset button it goes back to functional mode like it originally was

Funny, I don't think my flash automatically rebooted the phone either. Freaked me out! Does it boot n reboot normally now? Check the spl version when it boots to verify it is the version you flashed to! If it doesn't show u on boot then its in the bootloader which is the colorfull sceen ur talkin bout. With the power off, press vol down and power at the same time. Then just hit power again or soft reset to boot up.

If it goes to bootloader every time you start/restart then try reflashing, and make sure its the hard spl from cdma upgade section of TP2 forum!!!