Free Tethering? I think so.

[1999TL]

I am getting the error code 67 code as well. I Tried opening ICS and pressed disconnect. When I go to IE it say connot connect for an unknown reason. WTF. annoying. can't figure it out.

[B18DelSolT]

Originally Posted by 1999TL

I am getting the error code 67 code as well. I Tried opening ICS and pressed disconnect. When I go to IE it say connot connect for an unknown reason. WTF. annoying. can't figure it out.

Try this lemme know if it atleast gets the internet to work on your phone,
Go to setting
Phone
Click the services tab
click internet
Then click get settings

see if that fixes your issue.

[B18DelSolT]

Originally Posted by Jago

Hey Nice Sol.

Anyways, I was tethering two weekends ago by just disabling the NAI and my bill will come out next week so I will confirm if I was charged or not for it. A side effect I did notice (at least on my phone)....when the phone would go into sleep mode, it would not accept incoming texts or phone calls....as soon as I hit the power button to wake it up, the phone would ring and then say missed call....or like 4 or 5 missed texts would come in. Has anyone else exprienced this? Before I did the NAI disable, phone calls and texts would come in normally whether the phone was asleep or not. So I re-enabled the NAI and the phone started working normally again. Perhaps I am just crazy here.

Thanks man Got rid of it though, now im rocking a 2005 Acura TL

[1999TL]

I had to do a hard reset and I still had the problem. Took 30 mins on the phone with advanced tech support to get it to work. I tried the tech support before hard resetting and he told me I needed a hard reset. hmm. bet there was some way for it to work.

*side note. damn the phone is so much faster without my installed stuff. Probably the HTC home customizer.

[xanbo]

This is very good info, thanks everyone.

[getinked5]

Originally Posted by Primenall

There is no need to set it for PAM, just leave set to PCS.

It's so easy I don't understand why anyone has a problem, just make sure activesync is installed as it also installs the modem drivers.

1. Change registry entry for multi-nai
2. Plug usb in computer only
3. Open IE on 6800
4. Open Internet sharing, leave settings usb and PCS then hit connect
5. Plug usb into 6800, wait a few seconds for it to set up connection on computer, you can now close IE now as well.

That's it, remember when your done hit disconnect on your 6800.

i just followed these steps by Primenall...works perfect...my other phone i guess was malfunctioned piece of hardware. did a ROM swap hard reset everything...still didnt fix the 67 error code i was getting...just got a new phone monday and i'm tethering from it right now to test. works great Primenall.

[Primenall]

Yeah that's great, just remember to always hit "disconnect" before you unplug the cable or close Internet sharing as that can cause the 67 error if you don't.

[Jago]

I can confirm no additional charges from Sprint for tethering last month. I just got my bill. I tethered using the Multi-NAI disable registry tweek and also just the Internet Sharing w/o the tweeks. I suggest just disabling the NAI to be on the safe side though.

[stufff]

Originally Posted by kilmarac

Well after resetting the rom, I discovered an entry on sprint support that says if you try to connect three times and fail, it autolocks you from connecting to the net for 20 mins.

Are you sure you aren't just being locked out of the internet because you were yiffing?

[Vertigo]

PDANet! is the best no problems or headaches!!