SPC/MSL code of sprint diamond

Originally Posted by avhokie

Yes! I did this yesterday and it worked for me on my Sprint Diamond

This has worked for me as well. Not sure why that info isn't stickied.

[statepkt]

Yeah I had to try 3 ways before finally getting to this method.

Hope I saved some other people some time.

[dutchman71]

Cut and paste: (This worked, other methods did not for me...)

FYI, for all the Sprint people who don't what their MSL is:

I found this procedure on the xda forum and it works!!

I found a method that actually worked perfectly...

Use this method. I don't know who found it, but credit goes to them.

Change the following registry entries in:
HKEY_LOCAL_MACHINE\SOFTWARE\HTC\ATDbgLog
Enable: 1
LogMode: 1

* Wait a about 10 minutes (more time will not hurt), and soft-reset.

* Check to see that the file \Atlog\ATDbg0.txt has been created.

* Return the values back to what they were (most likely 0) waiting the same amount of time as above.

* Look in the ATDbg0.txt file and you should see a log of commands sent to the CDMA radio and there should be something like this somewhere in the file:

~~~~~~~~~~~SNIP~~~~~~~~~~~~
00:00:00 Tx:AT+HTC_RMSL=0\r
00:00:00 Rx:+HTC_RMSL: (###THIS WILL BE THE MSL###)\r\n0\r
00:00:00 Tx:AT+HTC_ROTKSL=0\r
00:00:00 Rx:+HTC_ROTKSL: 123456\r\n0\r
~~~~~~~~~~~SNIP~~~~~~~~~~~~


The numbers next to the Rx: +HTC_RMSL line should be your MSL

[ce tiger]

after registry change and soft-reset the .txt file is not being created.
any suggestions?

[Mr. X]

Originally Posted by ce tiger

after registry change and soft-reset the .txt file is not being created.
any suggestions?

you must wait 1 min after setting reg to 1, soft reset. then wait 5 min, set back to 0, then wait 1 min soft reset and the log will be there.

[ejdavis72]

Originally Posted by dutchman71

Cut and paste: (This worked, other methods did not for me...)

FYI, for all the Sprint people who don't what their MSL is:

I found this procedure on the xda forum and it works!!

I found a method that actually worked perfectly...

Use this method. I don't know who found it, but credit goes to them.

Change the following registry entries in:
HKEY_LOCAL_MACHINE\SOFTWARE\HTC\ATDbgLog
Enable: 1
LogMode: 1

* Wait a about 10 minutes (more time will not hurt), and soft-reset.

* Check to see that the file \Atlog\ATDbg0.txt has been created.

* Return the values back to what they were (most likely 0) waiting the same amount of time as above.

* Look in the ATDbg0.txt file and you should see a log of commands sent to the CDMA radio and there should be something like this somewhere in the file:

~~~~~~~~~~~SNIP~~~~~~~~~~~~
00:00:00 Tx:AT+HTC_RMSL=0\r
00:00:00 Rx:+HTC_RMSL: (###THIS WILL BE THE MSL###)\r\n0\r
00:00:00 Tx:AT+HTC_ROTKSL=0\r
00:00:00 Rx:+HTC_ROTKSL: 123456\r\n0\r
~~~~~~~~~~~SNIP~~~~~~~~~~~~


The numbers next to the Rx: +HTC_RMSL line should be your MSL

This has ALWAYS worked for me! When all else has failed.