Originally Posted by gsm1999 (Post 768689)

Stop with the BS Cr@p

Exact Memory location : 18E903E
read this address in RAM - you'll get spc

Other solution is a waste of time..

Setup com ##Diag#

Then connect read that location 6 bytes save file , then edit it

Originally Posted by blee0125 (Post 431602)

For Sprint Diamonds

Use CDMA Workshop and connect to the phone in diag mode.
Go to the "Security" Tab and hit "Read" SPC.
Select Universal Ram Method and Custom.
Address is: 018E:0190
Hit READ to find your SPC.

For Telus Diamonds I was told GetSPC works if you convert MEID to p-ESN but I haven't tried it myself.

Originally Posted by dutchman71 (Post 470897)

Cut and paste: (This worked, other methods did not for me...)

FYI, for all the Sprint people who don't what their MSL is:

I found this procedure on the xda forum and it works!!

I found a method that actually worked perfectly...

Use this method. I don't know who found it, but credit goes to them.

Change the following registry entries in:
HKEY_LOCAL_MACHINE\SOFTWARE\HTC\ATDbgLog
Enable: 1
LogMode: 1

* Wait a about 10 minutes (more time will not hurt), and soft-reset.

* Check to see that the file \Atlog\ATDbg0.txt has been created.

* Return the values back to what they were (most likely 0) waiting the same amount of time as above.

* Look in the ATDbg0.txt file and you should see a log of commands sent to the CDMA radio and there should be something like this somewhere in the file:

~~~~~~~~~~~SNIP~~~~~~~~~~~~
00:00:00 Tx:AT+HTC_RMSL=0\r
00:00:00 Rx:+HTC_RMSL: (###THIS WILL BE THE MSL###)\r\n0\r
00:00:00 Tx:AT+HTC_ROTKSL=0\r
00:00:00 Rx:+HTC_ROTKSL: 123456\r\n0\r
~~~~~~~~~~~SNIP~~~~~~~~~~~~


The numbers next to the Rx: +HTC_RMSL line should be your MSL

Originally Posted by karmaphones (Post 1632362)

What address would you read the MSL from on the Diamond using UNICDMA? I don't have Workshop. Thanks

Originally Posted by whitey10tc (Post 1636437)

Have you tried Bafs MSL grabber. Works like a charm on most WM devices.