|
||||
Re: SPC/MSL code of sprint diamond
Quote:
1. From the Dial Pad, enter ##3282#. 2. Tap the Edit radio button. 3. Enter six digit code: (XXXXXX). 4. Tap OK. 5. Tap Menu. 6. Tap Restore. 7. Tap OK at the Warning Prompt 8. Tap OK to reset the Device. 9. Perform an Update Data Profile Hope this helps. -s
__________________
"The difference between a smart person and a wise person is that a smart person knows
what to say and a wise person knows whether or not to say it." - unknown Funniest thread ever!! Don't just SAY "Thanks" PRESS ... Try it, it only takes a second! Last edited by slypher; 10-20-2008 at 07:27 AM. |
This post has been thanked 1 times. |
|
||||
Re: SPC/MSL code of sprint diamond
this is my email man iu can get me the spc / mSL luay_la@hotmail.com
|
This post has been thanked 1 times. |
|
||||
Re: SPC/MSL code of sprint diamond
thanks for the info, i'll give it a try...
__________________
Creator of iLife ROM Series Best... Member... Ever... |
|
||||
Re: SPC/MSL code of sprint diamond
Quote:
please help me. Thanks
__________________
Deepak Rahuja
|
|
||||
Re: SPC/MSL code of sprint diamond
http://forum.ppcgeeks.com/showthread.php?t=41203&page=2
Refer to my post, I got the MSL that way from my Sprint Diamond. |
This post has been thanked 1 times. |
|
||||
Re: SPC/MSL code of sprint diamond
Quote:
|
|
||||
Re: SPC/MSL code of sprint diamond
Cut and paste: (This worked, other methods did not for me...)
FYI, for all the Sprint people who don't what their MSL is: I found this procedure on the xda forum and it works!! I found a method that actually worked perfectly... Use this method. I don't know who found it, but credit goes to them. Change the following registry entries in: HKEY_LOCAL_MACHINE\SOFTWARE\HTC\ATDbgLog Enable: 1 LogMode: 1 * Wait a about 10 minutes (more time will not hurt), and soft-reset. * Check to see that the file \Atlog\ATDbg0.txt has been created. * Return the values back to what they were (most likely 0) waiting the same amount of time as above. * Look in the ATDbg0.txt file and you should see a log of commands sent to the CDMA radio and there should be something like this somewhere in the file: ~~~~~~~~~~~SNIP~~~~~~~~~~~~ 00:00:00 Tx:AT+HTC_RMSL=0\r 00:00:00 Rx:+HTC_RMSL: (###THIS WILL BE THE MSL###)\r\n0\r 00:00:00 Tx:AT+HTC_ROTKSL=0\r 00:00:00 Rx:+HTC_ROTKSL: 123456\r\n0\r ~~~~~~~~~~~SNIP~~~~~~~~~~~~ The numbers next to the Rx: +HTC_RMSL line should be your MSL |
This post has been thanked 4 times. |
|
|
|