VoiceCommand with Bluetooth headset

derk · #1 (**permalink**) 07-26-2007, 12:12 PM

is there a utility or a trick to to use the Bluetooth headset with Voice Command? Right now if I press the Windows logo button the speaker phone mic listens for my command rather than the headset.

Thanks

Bad Sector · #2 (**permalink**) 07-26-2007, 12:37 PM

After you install MSVC 1.6, you need to do a soft reset inorder for it to pick up the BT headset button for activating MSVC. On some headsets you may have to press and hold the button till you hear MSVC kick in.

derk · #3 (**permalink**) 07-26-2007, 09:17 PM

actually I'm trying to avoid using the button on the headset at all. With my disability I can't reach up and push the button. I'm trying to do as much as possible directly on the phone.

Right now if I want to use the headset with voice command I have to run BT Audio first, issue the commands, then go back to BT Audio to turn it off. I was hoping to get voice command to use the headset everywhere it goes to the speaker phone now.

dprout69 · #4 (**permalink**) 07-26-2007, 09:39 PM

I'm a little confused on what you are trying to do... obviously you have to tell the phone to listen either thru the phone itself or thru the headset so touching a button on the handset or the headset is mandatory. After that each unit will respond depending on which you selected i.e., you hit the headset button you can talk thru the head set, or hit the button on the handset and the mic on the handset will kick in. Can you confirm this happens as such?