Loading ROM Problem

k_dizzle · #1 (**permalink**) 01-27-2009, 07:36 PM

so everytime i try to load a new ROM to my device, i get 201 or can not get device data error. i am on vista. i have mobile 6.0 and usb connections are turned off. i have tried different usb ports. still nothing works.

**PDAPhoneJunkie** · #2 (**permalink**) 01-27-2009, 08:05 PM

Then you have hardware problems. Try a different Mini USB cable. If that fails then there is probably a broken pin on your phones port.

k_dizzle · #3 (**permalink**) 01-29-2009, 08:14 PM

i can give commands and get respones through mtty tho.

**PDAPhoneJunkie** · #4 (**permalink**) 01-29-2009, 09:38 PM

I'm not sure then. Try starting out flashing in bootloader from the start.

k_dizzle · #5 (**permalink**) 02-02-2009, 12:18 AM

than i get 100 error. model id error, says its not for my device.

**PDAPhoneJunkie** · #6 (**permalink**) 02-02-2009, 03:06 AM

What bootloader version do you have? Did you take a 2.05 and lower it to 2.02?

k_dizzle · #7 (**permalink**) 02-07-2009, 03:53 PM

yes. i did

**PDAPhoneJunkie** · #8 (**permalink**) 02-07-2009, 04:14 PM

That's what your problem is. You need to use NoID RUU. It is really stupid, and that is one of the worst guides in my opinion because n00bs try it then don't use NoID RUU cause the guide doesn't mention it. Once again, THERE IS NO REASON TO BRING 2.05 DOWN TO 2.02!

k_dizzle · #9 (**permalink**) 02-08-2009, 01:01 PM

well i was using the guide because i was stuck in 2.05! ok ill give it a try.

k_dizzle · #10 (**permalink**) 02-08-2009, 02:15 PM

so should i have it in bootloader from the start of the flash? when it tells me what my current device information and what its being changed to its all blank...? and its still telling my its not made for my device! i have to be doing something stupid wrong.
does the device have to be activated?