Did ya do it via this method?


Hack: Enable Incoming Calls During EV-DO
To receive incoming calls while in an active EV-DO (Power Vision) data session, and are running firmware 2.06.00 or later, you will need to perform a master reset of the device. Dial ##786# into the phone like a regular phone number, then proceed to reset the device using the option displayed. This will require your MSL, which you will have to get from Sprint customer service. If you have never done this before, it's best to have technical support walk you through performing a master reset, and then reprogramming the phone. The master reset will erase all data (and settings) on the device. This will then allow for incoming calls while in an EV-DO data session, however, in a 1xRTT (Vision) data session calls will still be redirected to voicemail.

ya I'm sure that's the one, I should have added it to the rom upgrade instructions, but didn't realize till later. did u cut and paste that? I will try and rewrite it and add to the rom upgrade tutorial.
Thx,
Mike

yes i did copy and paste it.

That's it.

It's obviously best to do it after the ROM upgrade since it requires a hard-reset ( :evil:) so if you can wait, do it when you're good and ready to do a new fresh install on your device.

Works well though.

Here are more detailed directions:

1. You need 3 numbers: The MDN (which is your cell phone number), the MSID, and the MSL. I called Sprint to get both the MSID and MSL numbers, though maybe there's a way to get them off of your phone?

2. Perform a reset by typing ##786# from the phone app. Be warned that this is a full hard reset, and will wipe all data.

3. After the reset is done and the device is booting, it automatically installs all the "customization" cabs. I let this finish completely, which took about 5 minutes.

4. Next, I re-programmed my MDN and MSID by typing ##XXXXXX# from the phone app. The "X"s in this case is your MSL number. (should be 6 digits I believe)

Finally, I went into settings --> phone --> services --> internet and then tapped "start" to begin the IOTA process. This took a few minutes.

After doing all this, incoming calls now interrupt my EVDO sessions. I'm not sure if there are better ways to get this done, but this is what I did and it worked for me.
Link

I dont mind that u did copy and paste, I was just wondering. Malatesta you mind if I add those instructions you just posted to the upgrade thread?

Knock yourself out! (I didn't write it, :lol: ) There is a link at the bottom of the quote that is difficult to see, but you can cite that person as the source or just that whole thread. :thumbright:

Re: UPDATED: Manually Update To Sprint PRL 20222
 

where did you get the PRL file?

Re: UPDATED: Manually Update To Sprint PRL 20222
 

once the file is updated and the phone reset, the PRL file can be deleted right?

yea you can delete the prl file.

I got it
 

No problem getting my MSL just told the CS rep I was programming my phone, didn?t ask me if I needed help with programming till after he gave me the MSL. This was EZ and now I have my MSL for other uses. Thanks!!