05-21-2008, 01:30 AM
|
||||
|
||||
|
Blank Screen after boot splash
Followed the guides, cooked a rom and flashed my XV6700. According to BuildOS all went well. When I reset the phone I get the boot splash with "ppcgeeks" and "Helmi_c" at the top, then it goes to a blank screen. Tried flashing again, got error 101. Tried hard rest several times now, tried UNI_ExitBootloader.exe, it worked once, but now the connection isn't recognized at all. HELP!
|
|
05-21-2008, 08:51 AM
|
||||
|
||||
|
Re: Blank Screen after boot splash
It's a black blank screen.
FYI, on a fresh install of BuildOS and after updating I get the following errors when I open Lenny's selections: ---------------------------When I open Helmi's text file I get: ---------------------------If I put the phone on the boot loader screen I can flash it with BuildOS and it shows the install progress on the boot loader screen. It always goes to the blank black screen after the boot splash.
|
|
05-21-2008, 11:12 AM
|
||||
|
||||
|
Re: Blank Screen after boot splash
So I tried just using the default selections in Helmi's kitchen, and my phone is alive again. Not sure what I'd selected that broke the bank but it looks like I'll have a few more hours of trial and error to get it where I want it. Anyone have some insight on these BuildOS errors?
Quote:
|
|
05-21-2008, 11:50 AM
|
||||
|
||||
|
Re: Blank Screen after boot splash
It looks like you were missing a key module. Or you may have selected a module that conflicted with another. This is quite common and, as you have found, a minimal install usually fixes that. Just use basic diagnostics and slowly and one module at a time that you want. When you hit a problem then you know what modules NOT to install.
__________________
|
|
05-21-2008, 10:24 PM
|
||||
|
||||
|
Re: Blank Screen after boot splash
I probably have NO idea what I am talking about here but I figure the worst that can happen is you waste 10 minutes flashing another failed result. I was reading another thread where someone was having a similar problem IIRC and it was something called PCM keyboard that was doing it ?? when he removed this the problem went away.
|
|
06-13-2008, 09:01 PM
|
||||
|
||||
|
Re: Blank Screen after boot splash
I just installed BuildOS 6.1 and did the update. As in previous post, I get the exact "modules not found" when BuildOS loads.
Is this a bug in the update? Never used it without the update.
|
|
06-16-2008, 02:01 PM
|
||||
|
||||
|
Re: Blank Screen after boot splash
That is normal, I get the same message. I just continue using it and it works fine. Maybe pay attention to what modules are "not found" and remove them from your build to avoid flashing problems.
|
 |
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
All times are GMT -4. The time now is 03:08 AM.
